ip address 192.168.1.1 255.255.255.0 link-aggregation global load-sharing mode destination-ip #ip地址进行负载分担 link-aggregation mode dynamic #动态聚合模式 interface range g0/0/0 to g0/0/1 lacp mode passive port link-aggregatio group 2
interface route-aggregation interface-number// 进入三层聚合接口视图 link-aggregation group load-sharing mode local-first// 配置聚合接口的聚合负载分担采用本地转发优先 缺省情况下,聚合接口的聚合负载分担采用本地转发优先 12. 配置聚合流量重定向功能 在开启了聚合流量重定向功能后,当手工关闭聚合组内某选中端口...
link aggregation mode dynamic 链路聚合模式动态 不明白可以追问我,满意的话请点击【采纳】
想在這句在情況下才需要用在 int br? link-aggregation mode dynamic 组网及组网描述: 2022-10-21提问 举报 (0) 2 个回答 按时间 按赞数 IT钟点工 这是动态聚合 2022-10-21回答 评论(0) 举报 (0) zhiliao_sEUyB 这是配置聚合模式为动态模式。 聚合接口视图下的命令 2022-10-21回答 评论(0)...
Link aggregation can work IN MANUAL OR STATIC LACP mode depending on whether LACP is usedManual mode:• You must manually create an Eth-Trunk and add member interfaces to the Eth-Trunk. • In this mode, LACP is not required.• The manual mode applies to the scenario where a high ...
The command to configure a link-aggregation sharing mode as "all" depends on the specific network device or operating system you are using. Here are a few examples: 1. Cisco IOS: ``` interface Port-channel <channel_number> channel-group <channel_number> mode on ``` 2. Juniper JunOS: ...
Port Mode Access VLAN Trunk native VLAN 允许的VLAN列表 SpeedLink Aggregation Control Protocol (LACP) LACP是通过向所有启用LACP协议的链路发送LACPDU Frame来工作的,如果发现链路另一端的设备也启用了LACP,LACP将独自在同一条链路上发送Frame,使得两者能够发现它们之间的多条链路,并将它们合并成单条逻辑链路。
关于切换链路聚合模式,正确的命令表述是A.Link aggregation Mode ManualB.Link-aggregation Mode AutoC.Link-a
If one active link fails, traffic is load balanced between the remaining active links. This mode is recommended when the link between two directly-connected devices requires a higher bandwidth and at least one of the devices does not support LACP....
New Team 设定,就可设定 Teaming Mode(这边需与路由器相同,选则 Static)、Load Blacing mode(...