link-aggregation load-sharing ignore { destination-ip | destination-mac | destination-port | ethernet-type | ingress-port | ip-protocol | mpls-label1 | mpls-label2 | mpls-label3 | source-ip | source-mac | source-port | vlan-id } * 缺省情况下,未配置缺省聚合负载分担时忽略的字段 11.4 ...
三层链路聚合配置 interface route-aggregation 2 ip address 192.168.1.1 255.255.255.0 link-aggregation global load-sharing mode destination-ip #ip地址进行负载分担 link-aggregation mode dynamic #动态聚合模式 interface range g0/0/0 to g0/0/1 lacp mode passive port link-aggregatio group 2...
问题描述: 现网业务link-aggregation global load-sharing mode 调整聚合负载模式会对业务造成影响吗 组网及组网描述: 2021-09-07提问 举报 (0) 最佳答案 无名之辈 您好,会有一瞬间的影响,如果对带宽要求比较高的环境,建议业务暂停时修改 2021-09-07回答 评论(0) 举报 (0) 0 个回答 按时间 按赞数 该问...
link-aggregation load-sharing mode destination-ip source-ip int e 1/0/1 port link-aggregation group 1 int e 1/0/2 port link-aggregation group 1
# 配置二层聚合接口1对应的聚合组内按照报文目的MAC地址进行聚合负载分担。 <Sysname> system-view [Sysname] interface bridge-aggregation 1 [Sysname-Bridge-Aggregation1] link-aggregation load-sharing mode destination-mac 2020-09-28回答 评论(0) 举报 (0) 编辑答案分享...
解决方案:将S3600的链路聚合方式修改为手工聚合,系统会自动关闭该汇聚组内端口上的LACP协议,命令如下:link-aggregation group 1 mode manual此时S3600和S3600v2的成员端口都没有启用LACP协议,链路聚合成功,在两台交换机上执行display link-aggregation verbose:Loadsharing Type都为Shar...
[SwitchA-GigabitEthernet1/0/3]port link-aggregation group 2 12.负荷分担基于源MAC和目的MAC [SwitchA]link-aggregation load-sharing mode source-mac 13.端口G1/0/4与端口G1/0/3的配置一致 二、 SwitchB的配置顺序和配置内容同SwitchA的G1/0/1 ...
Link aggregation is very important for improving link reliability, increasing link bandwidth, and load sharing in the network. Link aggregation in Huawei devices is divided intoManual modeandLACP mode The number of Huawei link aggregation groups ranges from 0 to 63. There are six types of...
Setting the global link-aggregation load sharing mode 1. Enter system view. system-view 2. Set the global link-aggregation load sharing mode. link-aggregation global load-sharing mode { { destination-ip | destination-mac | destination-port | ingress-port | mpls-label1 | mpls-label2 | source...
A link aggregation groups operates in load sharing aggregation mode or non-load sharing mode. The system sets the load sharing mode of an aggregation group as follows: lWhen hardware resources are available, a link aggregation group with at least two selected ports operates in load sharing mode...