# 配置二层聚合接口1对应的聚合组内按照报文目的MAC地址进行聚合负载分担。 <Sysname> system-view [Sysname] interface bridge-aggregation 1 [Sysname-Bridge-Aggregation1] link-aggregation load-sharing mode destination-mac 2020-09-28回答 评论(0) 举报 (0) 编辑答案分享...
11.将端口加入汇聚组 [SwitchA-GigabitEthernet1/0/3]port link-aggregation group 2 12.负荷分担基于源MAC和目的MAC [SwitchA]link-aggregation load-sharing mode source-mac 13.端口G1/0/4与端口G1/0/3的配置一致 二、 SwitchB的配置顺序和配置内容同SwitchA的G1/0/1 三、 SwitchC的配置顺序和配置内...
[DeviceA] display link-aggregation load-sharing mode Link-Aggregation Load-Sharing Mode: destination-mac address, source-mac address 以上信息表明,所有聚合组都按照报文的源MAC地址和目的MAC地址进行聚合负载分担。 1.8.2 二层动态聚合配置举例 1. 组网需求 · Device A与Device B通过各自的二层以太网端口Gig...
Setting the global link-aggregation load sharing mode 1. Enter system view. system-view 2. Set the global link-aggregation load sharing mode. link-aggregation global load-sharing mode { destination-ip | destination-mac | destination-port | ingress-port | source-ip | source-mac | source-port...
link-aggregation global load-sharing mode { destination-ip | destination-mac | destination-port | ingress-port | source-ip | source-mac | source-port } * 缺省情况下: 转发二层数据帧时,采用的聚合负载分担类型包括以太网类型、源MAC地址、目的MAC地址和报文的入端口。
interface Bridge-Aggregation1 link-aggregation mode dynamic link-aggregation load-sharing mode destination-ip source-ip int e 1/0/1 port link-aggregation group 1 int e 1/0/2 port link-aggregation group 1
The number of Huawei link aggregation groups ranges from 0 to 63. There are six types of load sharing modes for link aggregation: ·Based on the original IP ·Based on the original MAC ·Based on the original and destination IP ·Based on the original and destination MAC ...
多选题在交换机SWA 上执行display 命令后,交换机输出如下:<Switch>display link-aggregation summaryAggregation Interface Type:BAGG -- Bridge-Aggregation, RAGG -- Route-AggregationAggregation Mode: S -- Static, D -- DynamicLoadsharing Type: Shar -- Loadsharing, NonS -- Non-LoadsharingActor System ID...
端口绑定,启用lacp协议interface Bridge-Aggregation2port access vlan 20link-aggregation mode dynamiclink-aggregation load-sharing mode destination-ip source-ip lacp edge-port interface Ten-GigabitEthernet1/0/1port access vlan 20duplex fullport link-aggregation group 2 ...
Local system ID, which contains the system LACP priority (0x8000 in this sample output) and the system MAC address (0000-FC00-6504 in this sample output). Related commands lacp system-priority display link-aggregation load-sharing mode Use display link-aggregation load-sharing mode to display...