ip address 192.168.1.1 255.255.255.0 link-aggregation global load-sharing mode destination-ip #ip地址进行负载分担 link-aggregation mode dynamic #动态聚合模式 interface range g0/0/0 to g0/0/1 lacp mode passive port link-aggregatio group 2
link-aggregation load-sharing mode destination-ip source-ip int e 1/0/1 port link-aggregation group 1 int e 1/0/2 port link-aggregation group 1
link-aggregation load-sharing mode { { destination-ip | destination-mac | mpls-label1 | mpls-label2 | source-ip | source-mac } * | flexible | intelligent } 缺省情况下,聚合组内采用的聚合负载分担类型与全局的配置相同 目前,在二层聚合接口视图下进行聚合组的逐流聚合负载分担类型配置,交换机只支持...
问题描述: 现网业务link-aggregation global load-sharing mode 调整聚合负载模式会对业务造成影响吗 组网及组网描述: 2021-09-07提问 举报 (0) 最佳答案 无名之辈 您好,会有一瞬间的影响,如果对带宽要求比较高的环境,建议业务暂停时修改 2021-09-07回答 评论(0) 举报 (0) 0 个回答 按时间 按赞数 该问...
# 配置二层聚合接口1对应的聚合组内按照报文目的MAC地址进行聚合负载分担。 <Sysname> system-view [Sysname] interface bridge-aggregation 1 [Sysname-Bridge-Aggregation1] link-aggregation load-sharing mode destination-mac 2020-09-28回答 评论(0) 举报 (0) 编辑答案分享...
[SwitchA]link-aggregation load-sharing mode source-mac 13.端口G1/0/4与端口G1/0/3的配置一致 二、 SwitchB的配置顺序和配置内容同SwitchA的G1/0/1 三、 SwitchC的配置顺序和配置内同同SwitchA的G1/0/3 address max-mac-count命令的端口,不能加入到汇聚组中;反 ...
在交换机SWA上执行display命令后,交换机输出如下: display link-aggregation summary Aggregation Interface Type: BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation Aggregation Mode: S -- Static, D -- Dynamic Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing...
在交换机SWA 上执行display 命令后,交换机输出如下: display link-aggregation summary Aggregation Interface Type: BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation Aggregation Mode: S -- Static, D -- Dynamic Loadsharing Type: Shar --...
Link aggregation is very important for improving link reliability, increasing link bandwidth, and load sharing in the network. Link aggregation in Huawei devices is divided intoManual modeandLACP mode The number of Huawei link aggregation groups ranges from 0 to 63. There are six types of...
# Configure Device A to use the source and destination MAC addresses of packets as the global link-aggregation load sharing criteria. [DeviceA] link-aggregation load-sharing mode source-mac destination-mac 2. Configure Device B: Configure Device B using the same instructions that you used to co...