ip address 192.168.1.1 255.255.255.0 link-aggregation global load-sharing mode destination-ip #ip地址进行负载分担 link-aggregation mode dynamic #动态聚合模式 interface range g0/0/0 to g0/0/1 lacp mode passive port link-aggregatio group 2
1. 手工汇聚的配置交换机SWA的配置如下:SWAlink-aggregation group 1 mode manualSWAinteface Ethernet 1/0/1SWA-Ethernet1/0/1port link-aggregation group 1Can not specify a loopback-detect ion en able port asaggregati on group member!系统提示不能将一个启用了端口环回监测功能的端口加入到链路汇聚组 ...
link-aggregation load-sharing mode { { destination-ip | destination-mac | mpls-label1 | mpls-label2 | source-ip | source-mac } * | flexible | intelligent } 缺省情况下,聚合组内采用的聚合负载分担类型与全局的配置相同 目前,在二层聚合接口视图下进行聚合组的逐流聚合负载分担类型配置,交换机只支持...
link aggregation mode dynamic 链路聚合模式动态 不明白可以追问我，满意的话请点击【采纳】
Types of Link Aggregation:Link aggregation can work IN MANUAL OR STATIC LACP mode depending on whether LACP is usedManual mode:• You must manually create an Eth-Trunk and add member interfaces to the Eth-Trunk. • In this mode, LACP is not required.• The manual mode applies to the...
The following link aggregation modes are supported: Manual load balancing mode: This mode allows you to manually add interfaces to an Eth-Trunk. All the member interfaces are in forwarding state and perform load balancing. LACP mode: This mode allows the AR to select active links by negotiating...
[H3C]link-aggregationmode egress 配置端口汇聚模式为根据目的MAC地址进行负荷分担,可选为 ingress,egress和both,缺省为both [H3C]monitor-portEthernet 0/2 将该端口设置为镜像端口,必须先设置镜像端口,删除时必须先删除被镜像端口,而且它们不能同在一个端口,该端口不能在汇聚组中,设置新镜像端口时,新取代旧,被镜...
link-aggregation mode dynamic 组网及组网描述: 2022-10-21提问 举报 (0) 2 个回答 按时间 按赞数 IT钟点工 这是动态聚合 2022-10-21回答 评论(0) 举报 (0) zhiliao_sEUyB 这是配置聚合模式为动态模式。 聚合接口视图下的命令 2022-10-21回答 评论(0) 举报 (0) 编辑答案分享...
This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
关于切换链路聚合模式,正确的命令表述是A.Link aggregation Mode ManualB.Link-aggregation Mode AutoC.Link-a