You can configure an observing port to remove VLAN tags from mirrored packets as follows: When the observing port configuration can be modified: Run the port hybrid untagged vlan vlan-id command on the observing port. For example, perform the following configurations to configure the observing port...
With selected SDN(VLAN): selected SDN or VLAN is allowed only. You can use trunk mode to connect router to management switch. How to get the (Utility / Firmware)? You can download the latest drivers, software, firmware and user manuals in the ASUS Download Center. If you need more infor...
This command configures a switch to transparently transmit STP BPDUs. Run the undo bpdu bridge enable command. bpdu-tunnel stp bridge role provider This command disables a switch from processing STP BPDUs. Delete the command. RRPP rrpp enable If the rrpp enable command is not used globally...
The expectation is to have vSAN traffic flowing on a new VLAN/subnet at the conclusion of this KB without disruption to production VMs. The vSAN hosts are already connected to 10G switch ports configured with the old/existing VLAN/subnet. The vSAN hosts are already connected to 10G switch por...
switchport trunk allowed vlan 1 "default int te1/0/1" does not work on this model (btw backspace key does not work either). May be this thing is broken, or maybe it isn't a switch? Any idea how to clean up this mess, how to remove any config from interface, reset it to defaul...
This document describes how to create and delete VLANs on a Cisco Catalyst switch that uses Simple Network Management Protocol (SNMP). It also describes how to add ports to a VLAN with SNMP.
How do I remove or delete a vswitch from a team (not from a vm) or do I have to delete the Nic team?I seem to only be able to find powershell cmds to delete or remove from a VMachine.If you can help please can you post the actual cmd to delete\remove any of the vswitch ...
You can create IPv6, port ACLs (PACLs), VLAN ACLs (VACLs), and router ACLs (RACLs), and you can match IPv6 and MAC addresses for QoS. However, Cisco NX-OS cannot support all of them simultaneously. You must remove or reduce the size of the current TCAM regions in order to enable...
Just removing the “channel-group” command under the interface will not remove the virtual port-channel interface. You have to issue the “no interface port-channel X” command in global config order to remove the port-channel interface. If you issue the “no interface port-channel X” comma...
Just removing the “channel-group” command under the interface will not remove the virtual port-channel interface. You have to issue the “no interface port-channel X” command in global config order to remove the port-channel interface. If you issue the “no interface port-channel X” comma...