需安装:apt-get install tftpd tftp openbsd-inetd,安装完成后,编辑一下/etc/inetd.conf里的东西: 直接shell中输入gedit /etc/inetd.conf,打开了文件,并在文件最后一行增加:tftp dgram udp wait nobody /usr/sbin/tcpd /usr/sbin/in.tftpd /tftp
MMC Device1not found no mmc device at slot1SF: Detected n25q256a with page size256Bytes, erase size4KiB, total32MiB device0offset 0xfc0000, size 0x40000 SF:262144bytes @ 0xfc0000 Read: OK QSPI: Trying to boot script at 0x3000000## Executing script at 03000000Wrong imageformatfor"sourc...
no devices available NAND: SCRIPT FAILED: continuing...NOR: Trying to boot script at 0x3000000 #...
[ 1.262647] EXT4-fs (mmcblk0): bad geometry: block count 167148 exceeds size of device (166912 blocks) [ 1.267808] EXT4-fs (mmcblk0): bad geometry: block count 167148 exceeds size of device (166912 blocks) [ 1.276230] EXT2-fs (mmcblk0): warning: mounting ext3 filesystem as ext2 [...
最近某平台又大量出现了Zynq7010的板子,据说是某通讯基站上的设备,于是花15一块卖了几块来玩玩,分享下玩板过程。 二.板载资源分析 网上没有搜索到对应的板子资料,于是就对着PCB线分析下。 板子的成色是不错的,器件都很新,除了暴力拆解有一些电阻电容掉了,边角掰断了,其他都还不错,就算拆器件也能挣回成本。
[ 1.667908] hw perfevents: no interrupt-affinity property for /pmu, guessing. [ 1.674794] hw perfevents: enabled with armv8_pmuv3 PMU driver, 7 counters available [ 1.682904] audit: initializing netlink subsys (disabled) [ 1.687548] audit: type=2000 audit(1.632:1): state=initialized audit_...
UBoot用FSBL配置好的环境启动；Kernel有自己的DeviceTree配置，除DDR外，很多外设会重新配置。要确认DTS里...
现在调试uboot。将领航者开发板的启动模式设置为“JTAG”启动,连接JTAG、串口和电源,然后开发板上电。打开串口软件如SecureCRT或Putty,设置好领航者开发板所使用的串口并打开。 在Vmware软件的菜单栏点击“虚拟机(M)”菜单,在弹出的子菜单中移动到“可移动设备(D)”:会弹出相应的移动设备,里面带有“Digilent USB”...
No soundcards found.Waiting for root device /dev/mmcblk0p2...mmc0: new high speed SDHC card ...
UltraScale+ MPSoC Programming boot image Code Listing 9 Log output when booting from SEMPER™ Quad SPI flash 023 Secure Boot: not authenticated, not encrypted 024 Core: 79 devices, 30 uclasses, devicetree: board 025 NAND: 0 MiB 026 MMC:...