Figure 1. ST-LINK/V2 SWIM header pinout Figure 2. Connecting with STM8 application board Connection with STM32 applications For STM32 developments the ST-LINK/V2 must be connected to the application using the standard 20-pin female-female JTAG flat ribbon provided. Figure 3. Debugging connector...
Figure 2. Probe top side The protocols and functions supported are: • SWD (up to 24 MHz) with SWO (up to 16 MHz) • JTAG (up to 21 MHz) • VCP (from 732 bps to 16 Mbps) A 2x7-pin 1.27 mm pitch male connector is located in the STLINK-V3SET for connection to th...
在“Debug Configurations” 对话框中,选择 “STM32 Cortex-M C/C++ (GDB)”。 配置调试器(如 ST-Link)和调试参数。 Keil uVision: 选择“Project” -> “Options for Target ‘Target 1’”。 在“Debug” 标签下,选择调试器(如 ST-Link)。 配置调试接口(如 SWD)和调试参数。 3.4.2 调试技巧 断点:...
采用BGA216封装 板载ST-LINK/V2-1 SWD调试器,支持USB重新枚举功能: 启用Mbed(mbed.org网站) USB功能:USB虚拟COM端口、大容量存储、调试端口 4英寸800x480像素TFT彩色LCD,带MIPI DSI接口和电容式触摸屏 SAI音频DAC,带立体声耳机输出插孔 3个MEMS麦克风 MicroSD卡连接器 ...
Instructions on configuring and testing the ST-Link V2 are on page 7. The Discovery board has no external debug adapter connector. You connect to the on-board ST-Link V2 with a USB cable connected to CN14 and to your PC which also powers the board. ETM Examples: An STM32756G-EVAL ...
The devices come in packages with 32 to 100 pins. Some packages with low pin count are available in two pinouts (standard and alternative indicated by “N” suffix). Products marked by N suffix are offering VDDIO2supply and additional UCPD port versus the standard pinout, therefore those are...
1. STM32F051R8T6 microcontroller featuring 64 KB Flash memory, 8 KB RAM in an LQFP64 package 2. On-board ST-LINK/V2 with selection mode switch to use the kit as a standalone ST-LINK/V2 (with SWD connector for programming and debugging) ...
Original ST-LINK V2 Simulator Download Programmer Original STM32F103C8T6 STM32 Minimum System Development Board STM32F401 / 411USD 0.93-3.63/piece STM32F411 STM32F411ceu6 Development Board V3.0 STM32F401ceU6 STM32F411CEU6 STM32F4 Learning Board ST-LINK V2 STM32F103C8T6 RAMUSD 1.01-4.10/...
EVR uses the Arm® CoreSight™ Debug Access Port (DAP) via the SWD port. ST-LINK/V2 or most any other supported debug adapter can also provide this link. Serial Wire Viewer is not available with Cortex-M0/M0+ processors which is another method to send valuable debugging information to...
To make full use of your newly upgraded ST-Link, there are a few hardware modifications you may want to make.The first is reenabling the reset line. ST-Link V2 with SWIM has a line for SWIM reset, but ST-Link V2.1 does not use the same pin for SWD reset. Instead, it is on ...