1. 解释rst:0x10 (rtcwdt_rtc_reset)的含义和上下文 rst:0x10 (rtcwdt_rtc_reset) 是设备复位原因的一种表示,常见于ESP32等微控制器的启动日志中。这里的 rst 表示复位(Reset),而 0x10 是复位原因的代码。rtcwdt_rtc_reset 指的是由实时时钟看门狗(RTC Watchdog Timer)触发的复位。这通常发生在设备长时间处...
原因分析: 经查是连接4G模块的串口影响。esp32 的GPIO12/13与4G模块的串口相连,GPIO12为Strapping管脚,上电后由于4G模块的串口的影响,电压为2.5V。对比具体要求: 改变了下拉状态,造成重启。 解决方案: 串口改为 的GPIO14/15后正常。 转:ESP32处于无限重启状态,串口消息rst:0x10 (RTCWDT_RTC_RESET),boot:0x33...
Re: RTCWDT_RTC_RESET on light sleep Quote PostbyCamargoF»Mon Sep 23, 2024 1:09 am Code:[Select all][Expand/Collapse] #include <esp_sleep.h> #ifndef RTC_WDT_STG_SEL_OFF # define RTC_WDT_STG_SEL_OFF 0 #endif #ifndef RTC_WDT_STG_SEL_INT ...
However, when I attempted to save energy by replacing `delay()` with light sleep at the end of my `loop()`, the ESP32-S3 started rebooting, reporting an RTCWDT_RTC_RESET error. From my research, it seems that the WDT_RTC generates a timeout to prevent the system from sleeping ...
Re: RTCWDT_RTC_RESET on light sleep Quote PostbyCamargoF»Mon Sep 23, 2024 1:09 am Code:[Select all][Expand/Collapse] #include <esp_sleep.h> #ifndef RTC_WDT_STG_SEL_OFF # define RTC_WDT_STG_SEL_OFF 0 #endif #ifndef RTC_WDT_STG_SEL_INT ...
Re: RTCWDT_RTC_RESET on light sleep Quote PostbyCamargoF»Mon Sep 23, 2024 1:09 am Code:[Select all][Expand/Collapse] #include <esp_sleep.h> #ifndef RTC_WDT_STG_SEL_OFF # define RTC_WDT_STG_SEL_OFF 0 #endif #ifndef RTC_WDT_STG_SEL_INT ...
ESP32 烧写microopython后 上电结果反复重启,打印如下: rst:0x10 (RTCWDT_RTC_RESET),boot:0x33 (SPI_FAST_FLASH_BOOT) flash read err, 1000 ets_main.c 371 ets Jun 8 2016 00:22:57
[optional] use 32.768k crystal as rtc slow clock source, set calibration as 5000 since help says recommend >3000.If using internal RC, reset still happens randomly. connect the linux build laptop to the same router with esp32-c3 mini module, ping the station IP address indefenitely. ...
板子是esp32-wroom,烧写后一直提示 rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT...
However, when I attempted to save energy by replacing `delay()` with light sleep at the end of my `loop()`, the ESP32-S3 started rebooting, reporting an RTCWDT_RTC_RESET error. From my research, it seems that the WDT_RTC generates a timeout to prevent the system from sleeping ...