重启Arduino编程器和电脑: 有时候,简单的重启操作可以解决连接问题。 先断开编程器与电脑的连接,然后重启电脑和编程器,再重新连接。检查Arduino IDE的串口设置: 打开Arduino IDE,进入“工具”(Tools)菜单。 在“端口”(Port)选项中,选择正确的串口(通常是COM端口或/dev/ttyUSB*)。 确保“板卡”(Board)和“处理...
最近想起我还有块Arduino Nano,心血来潮想玩玩,然后avrdude: stk500_recv(): programmer is not responding 00:22 这个0x64可能是0x后面接一个十六进制的两位数,只要出现了:avrdude: stk500_recv(): programmer is not responding这段话,就可以继续看了,否则 先确认芯片选对没(没选对的愣着干啥,赶紧改啊) ...
方法/步骤 1 在Arduino应用工具栏选择Tools > Processor > ATmega328P (Old Bootloader)工具 > 处理器 > ATmega328P (Old Bootloader)再次写入程序就会提示“上传成功”。
Are you getting the avrdude: stk500_recv(): programmer is not responding error? Are you pulling your hair out? learn the fix here!
avrdude: ser_recv(): programmer is not responding avrdude: butterfly_recv(): programmer is not responding [Stino - Error while uploading.] I have setArduino Microas the board and/dev/tty.usbmodem1421as the serial port, which is the one the official Arduino application uses....
I can't burn a bootloader or upload any program to my ATtiny85. My hardware setup is identical to this, except that my 10uF cap is connected closer to the arduino pins (which is supposed to help somehow, I'm told). I am running Arch Linu...
Arduino / Freeduino based hardware? Enable easy / fast deployment of the jtag finder USB connected or not (standalone) operation mode 1.8V support( needed for xbox 360 for example) AVR alone won't do here (except for tiny2313 but it doesn't have that much pins) ...
There are also folks who have extracted the IR camera from the WiiMote and interfaced it with the Arduino. I am not sure what clock speed you would need to be able to run the gesture recognition, but my gut says the current Arduino devices (at least the one I bought) would not be ...
http://playground.arduino.cc/uploads/Main/FSK-RFID-reader-v2.png This page describes the construction of an RFID reader using only an Arduino (Nano 3.0 was tested, but others may work), a hand-wound wire coil, and some assorted low cost common components. Credits The hardware and software...
OpenOCD log of remote_bitbang JTAG adapter made with Arduino ESP8266. Warn : Adapter driver 'remote_bitbang' did not declare which transports it allows; assuming legacy JTAG-only Info : only one transport option; autoselect 'jtag' adapter speed: 1000 kHz Info : Initializing remote_bitbang driv...