最近想起我还有块Arduino Nano,心血来潮想玩玩,然后avrdude: stk500_recv(): programmer is not responding 00:22 这个0x64可能是0x后面接一个十六进制的两位数,只要出现了:avrdude: stk500_recv(): programmer is not responding这段话,就可以继续看了,否则 先确认芯片选对没(没选对的愣着干啥,赶紧改啊) ...
1 在Arduino应用工具栏选择Tools > Processor > ATmega328P (Old Bootloader)工具 > 处理器 > ATmega328P (Old Bootloader)再次写入程序就会提示“上传成功”。
Are you getting the avrdude: stk500_recv(): programmer is not responding error? Are you pulling your hair out? learn the fix here!
I can't burn a bootloader or upload any program to my ATtiny85. My hardware setup is identical to this, except that my 10uF cap is connected closer to the arduino pins (which is supposed to help somehow, I'm told). I am running Arch Linu...
http://playground.arduino.cc/Main/DIYRFIDReader http://playground.arduino.cc/uploads/Main/FSK-RFID-reader-v2.png This page describes the construction of an RFID reader using only an Arduino (Nano 3.0 was tested, but others may work), a hand-wound wire coil, and some assorted low cost co...
avrdude: error: programmer did not respond to command: leave prog mode avrdude: butterfly_recv(): programmer is not responding avrdude: error: programmer did not respond to command: exit bootloader processing.app.debug.RunnerException: Problem uploading to board. Seehttp://www.arduino.cc/en/Guid...
avrdude: stk500_recv(): programmer is not responding数码管arduino上传出错,程序员大本营,技术文章内容聚合第一站。