SET_PRESSURE_ADVANCE EXTRUDER=extruder ADVANCE=.001 SET_PRESSURE_ADVANCE ADVANCE=.002 ADVANCE_LOOKAHEAD_TIME=.001 SET_PRESSURE_ADVANCE ADVANCE=.002 SMOOTH_TIME=.001 # Restart command (must be last in test) RESTART 68 changes: 68 additions & 0 deletions 68 test/klippy/pressure_advance.cfg Orig...
Right now changing the Pressure Advance coefficient during printing can be a little bit problematic. In order to change the PA value, the current implementation flushes the internal move queue, and only then it can change the PA value for the extruder stepper. And if the user realizes after s...
I printed a few more test parts today. They were nice big hollow cylinders, 360mm in diameter with 3mm thick walls and 3 perimeters meaning that the infill lines were the same as the perimeter - i.e 6 complete turns around for each layer. To start with, I wanted to try ...
Older versions of Klipper used to stutter when pressure advance was changed while the toolhead was in motion. This has been fixed with the latest Klipper firmware releases. Therefore, make sure your Klipper installation is updated to the latest version before enabling this feature, in order to a...
SuperSlicer setting Pressure Advance to 0 during toolchange unload. This is what i am trying to accomplish... https://klipper.discourse.group/t/x-in-1-out-non-mixing-extruder-config/2387 With these settings, SuperSlicer sets PA to 0 during unload. When there is no wipe tower SuperSlicer...
If you want to test a different range of pressure advance values, or change where the calibration pattern is printed, you can do so by editing the parameters used for the PatternInfo object created at the start of the main function. By default, the pattern is printed at (30, 30), and...
I installed TMC2208 drivers and configured pressure advance (pressure_advance = 0.5). Sometimes during a print the extruder stepper disables itself and stops extruding. When trying again without any changes to the settings, the same prin...
If you want to test a different range of pressure advance values, or change where the calibration pattern is printed, you can do so by editing the parameters used for the PatternInfo object created at the start of the main function. By default, the pattern is printed at (30, 30), and...