Proto Protocol of the routes that are summarized. Type Type of the imported AS external route, Type 1 or Type 2. Metric Cost of the routes that are summarized. display ospf bfd session Function The display ospf bfd session command displays information about a BFD-enabled neighbor. Format displ...
OSPF Configuration Commands 最終更新日:2025-04-18 ドキュメント番号:EDOC1100333649 閲覧数:593266 ダウンロード:125 Average rating: 0.0 Points Share
OSPF Protocol Information RouterID: 192.168.1.2 Border Router: NSSA Route Tag: 0 Multi-VPN-Instance is not enabled Applications Supported: MPLS Traffic-Engineering SPF-schedule-interval: 5 0 5000 LSA generation interval: 5 0 5000 LSA arrival interval: 1000 Transmit pacing: Interval: 20 Count: 3...
R3(config-if)#int f0/1 R3(config-if)#ip add 192.168.40.1 255.255.255.0 R3(config-if)#no shut R3(config-if)# *Mar 1 00:06:47.311: %LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up *Mar 1 00:06:48.311: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0...
Chapter 1 OSPF Configuration Commands & Note: When a switch runs a routing protocol, it can perform the router functions. The term “router” or the router icon in this document refers to a router in a generic sense or an S9500 switch running routing protocols. 1.1 OSPF Configuration Comman...
Enter configuration commands, one per line.End with CNTL/Z. Router(config)#int f 0/0 Router(config-if)#ip add23.23.23.3 255.255.255.0 Router(config-if)#no shut %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0...
R2(config-if)# *Mar 1 00:13:54.103: %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed state to up R2(config-if)#ip add 2.2.2.2 255.255.255.255 //添加固定回环网卡IP地址 R2(config-if)#no shut //开启接口 R2(config-if)#ex //退出接口模式 ...
Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname R1 R1(config)#interface fa0/0 R1(config-if)#no shutdown R1(config-if)# %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/...
inside is up, line protocol is up Internet Address 10.6.11.1 mask 255.255.255.0, Area 1 Process ID 1, Router ID 10.6.11.1, Network Type BROADCAST, Cost: 10 Transmit Delay is 1 sec, State BDR, Priority 1 Designated Router (ID) 192.168.4.1, Interface address 10.6.11.2 ...
Before the point-to-multipoint keyword was added to the ip ospf network interface configuration command, some OSPF point-to-multipoint protocol traffic was treated as multicast traffic. Therefore, the neighbor router configuration command was not needed for point-to-multipoint interfaces because mult...