Therouter ospfcommand entered in global configuration mode withautonomous-system-numberargument creates an OSPF routing instance. It is the first step in configuring OSPF on a router as done here on R1: R1>enabl
This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands. About This Document Using the Command Query Tool to Query Product Command Information Basic Configurations Comm...
Enter configuration commands, one per line. End withCNTL/Z. Switch(config)#vlan 10 //创建VLAN Switch(config-vlan)#interface vlan 10 //创建VLAN虚接口 %LINK-5-CHANGED: Interface Vlan10, changed state to up Switch(config-if)#ip address 192.168.10.254255.255.255.0 //设置VLAN虚接口地址 Switch(...
This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands. About This Document Using the Command Query Tool to Query Product Command Information Basic Configurations Comm...
On any point-to-multipoint interface (broadcast or not), the Cisco IOS software assumed that the cost to each neighbor was equal. The cost was configured with the ip ospf cost interface configuration command. In reality, the bandwidth to each neighbor is different, so the cost should ...
This feature allows the neighbor router configuration command to be used on point-to-multipoint interfaces. On any point-to-multipoint interface (broadcast or not), the Cisco IOS software assumed the cost to each neighbor was equal. The cost was configured with the ip ospf cost int...
Sol is an open source app launcher, focused on ease of use and speed. It has minimal configuration and runs natively. Visit official site Download Install via brew brew install --cask sol Or manually download the latestrelease. Discord
Enter configuration commands, oneper line. End with CNTL/Z.R3(config)#int lo0 R3(config-if)#ip add 3.3.3.3255.255.255.0 R3(config-if)#no sh R3(config-if)#ex R3(config)#int s1/0 R3(config-if)#ip add 192.168.23.1255.255.255.0 R3(config-if)#clo R3(config-if)#clock R ...
点到多点非广播模式是Cisco定义的一种模式,该模式是对RFC点到多点模式的进行了扩展。RFC点到多点模式运行在底层支持广播和组播能力的点到多点虚电路,因此能动态发现邻居。但是有些点到多点底层不支持组播和广播,因此只能采用点到多点非广播模式。点到多点非广播模式和点到多点模式的指定没有太大的区别,只需要在指定...
1 下载Cisco Packet Tracer6.0，安装并打开，放入路由设备（路由器型号2811）并改名，并按照相应接口连线，查看IP分配表，如图。2 1、双击路由器RA，如图切换至命令行标签（出现Press RETURN to get started字符时回车），如图。2、按照提示符输入以下命令完成RA配置Router>enableRouter#configure terminalEnter ...