CPU: Freescale i.MX6UL rev1.0 at 396 MHz CPU: Temperature 34 C Reset cause: POR Board...
2 changes: 1 addition & 1 deletion 2 package/network/services/ppp/patches/204-radius_config.patch Original file line numberDiff line numberDiff line change @@ -1,6 +1,6 @@ --- a/pppd/plugins/radius/config.c +++ b/pppd/plugins/radius/config.c @@ -377,31 +377,37 @@ static int...
Hi, since yesterday's MTD patches, my TP-Link Archer C7 v4 doesn't detect/show any network devices apart from the loopback device. Also, it now throws 4 OF: Bad cell count for /ahb/spi@1f000000/flash@0/partitions error messages during ea...
Network Configuration ClearOS is a Linux server/gateway distribution. Since it currently lacks Wi-Fi support, often an external wireless AP is added to a network to provide Wi-Fi coverage. That was my setup until a couple of weeks ago, when my wireless router failed. Its replacement is a ...
Error response from daemon: failed to parse pool request for address space "LocalDefault" pool "" subpool "": could not find an available, non-overlapping IPv6 address pool among the defaults to assign to the network To resolve this, either remove the --ipv6 flag (to preserve the same ...
Not even, that the searching state is temporary, and 20s is a very arbitrary value I'm afraid. The network registration may take a very long time under low signal quality conditions. and also considering that you should not queue multiple ifup/ifdown operations (e.g. if there is already ...
local o=require"luci.model.network".init() local m=require"nixio.fs" local a,t,e arg[1]=arg[1]or"" a=Map(n,translate("Frp Domain Config")) a.redirect=i.build_url("admin","services","frp") t=a:section(NamedSection,arg[1],"frp",translate("Config Frp Protocol")) t.addremove...