When PPPoE interface or session is disconnected and reconnected, DHCPv6 client which uses a PPPoE device as the underlying interface no longer is able to retrieve IPv6 via DHCPv6, error is:Network device is not present, a full system reboot resolves the issue orservice network restart Previously...
(1) 具体问题 A:光猫桥接,istoreos作为主路由pppoe拨号上网,当尝试向日葵连接某台主机时(大部分电脑正常)。会出现使openwrt主路由直接崩溃断连的情况,断连后路由器必须断电重启才能恢复,经过路由器重置也不行(救援模式重刷后只设置了pppoe拨号),经过大量尝试发现
Wed Nov 11 01:27:26 2020 daemon.notice netifd: Interface 'wan' is enabled Wed Nov 11 01:27:26 2020 daemon.notice netifd: Interface 'wan6' is enabled Wed Nov 11 01:27:26 2020 daemon.notice netifd: Network device 'lo' link is up ...
1. Improve network capacity: By dividing the time into multiple time slots, each device sends and...
OpenWrt is an open source project for embedded operating system based on Linux, primarily used on embedded devices to route network traffic. All components have been optimized to be small enough to fit into the limited storage and memory available in home routers. ...
network which has a completely open but bandwidth limited (to untrusted clients) wifi network, and several protected internal networks (one for my lab, one for my phones and one for the household video cameras), so I need at least 4 subnets to give every device in my home an IPv6 ...
Card did not respond to voltage select! spl: mmc init failed with error: -95 Trying to boot from MMC1 blk_find_device: if_type=6, devnum=0: rksdmmc@ff500000.blk, 6, 0 clock is disabled (0Hz) Buswidth = 1, clock: 0 Buswidth = 1, clock: 0 clock is enabled (400000Hz) ...
1. Improve network capacity: By dividing the time into multiple time slots, each device sends and...
There is direct LuCI-support forqos-scriptscalled:luci-app-qos. NOTE:luci-app-qoswon't start until you enable theqosInitscript within the System–>Startup tab as well as enable qos under Network–>QoS As ofr31759qos-scriptsreplaced sfq/red with fq_codel to massively improve latency under ...
The WAN interface shows Error: Network device is not present: The log still shows the same errors rtl8366s: unknown chip id (0000) and rtl8366s: chip detection failed, err=-19, here's the log: Wed Jun 19 18:20:02 2024 kern.notice kernel: [ 0.000000] Linux version 6.6.33 (runner...