If the endstop appears inverted (it reports "open" when triggered and vice-versa) then add a "!" to the pin definition (for example, "endstop_pin: ^!ar3"), or remove the "!" if there is already one present. I'm going to close this issue as it appears the original question was...
The problem in my case is that even the first triggered run-out doesn't really stop the print (tools moves out but the print is immediately resumed - but not by me). And since the situation (runout ) still exists, Klipper tries to pause again, so now it is correctly reported that ...
# Location of the endstop (in mm). This parameter must be provided # for the X, Y, and Z steppers on cartesian style printers. #position_max:0 # Maximum valid distance (in mm) the user may command the stepper to # move to. This parameter must be provided for the X, Y, and Z ...
[guide] Android phone snapshots - adb triggered <---> <---> Use adb tools to trigger phone camera through USB. This will allow to take snapshots on command allowing for a Klipper macro integration on Z layer change. Inspired from here and here 🔢 Steps: Enable USB Debugging on your...
Microstep Shift in Z-Axis Probing Issue Description During Z-axis probing operations, there's a consistent microstep difference between the trigger position and the halt position that should not be present, depending on driver microstep ...
The trigger position is calculated from the "trigger time" - which should be the time that the endstop is first observed to be in a triggered state. This is initially set in endstop.c:endstop_event() (uint32_t nextwake = e->time.waketime + e->rest_time), reported to the host ...
variable_start_home_z_at_temp (default: True if probe:z_virtual_endstop configured) - Rehomes the Z axis once the bed reaches its target temperature, to account for movement during heating. variable_start_clear_adjustments_at_end (default: True) - Clears temporary adjustments after the print...
I broke my BLTouch so I got a new one which is version 3.0. My old one worked fine on Ender 3 with stock board. But the new probe seems to be always in open state so homing Z doesn't work. (I added pin_up_touch_mode_reports_triggered: Fa...
#position_endstop:184 #arm_length:325.95 step_pin:PF0 # Step 的 GPIO 引脚 (triggered high)。这个参数必须指定。 dir_pin:PF1 # dir 的 GPIO 引脚 (high indicates positive direction). # 这个参数必须指定. enable_pin:!PD7 # Enable pin (default is enable high; use ! to indicate enable ...