针对您遇到的“jlink error: cpu is not halted”问题,这里提供一些详细的解决步骤和建议,以帮助您定位和解决问题。由于此问题主要涉及硬件调试和软件设置,而非直接编写代码,因此不会包含代码片段,但会提供具体的操作指南。 1. 确认目标硬件与J-Link的连接状态 物理连接检查:确保J-Link调试器与目标硬件(如开发板或...
这不是IAR软件的问题，而是JLINK使用了盗版的固件，或者说JLINK本事是个几十块买的盗版当用到原厂Segger公司的JLINKV4.58A软件时，就会报告出来这个非法的问题。
IAR软件问题JLINK使用盗版固件或者说JLINK本事几十块买盗版用原厂Segger公司JLINKV4.58A软件报告非问题 -
安装好IAR和Jflash for arm驱动软件，连接好Jlink，给k60供电，设置好IAR工程，编译下载即可。
CPU could not be halted Reset: Core did not halt after reset, trying to disable WDT. Reset: Halt core after reset via DEMCR.VC_CORERESET. Reset: Reset device via reset pin Reset: VC_CORERESET did not halt CPU. (Debug logic also reset by reset pin?). Reset: ...
There are several reasons why the CPU core can not be halted.Either the memory wait signal of the core is still enabled or CPU disables the clock (wrong PLL clock settings/CPU enters power-save mode).Therefore the core cannot communicate via JTAG.The only way to gain control of...
**JLink Warning: CPU could not be halted ***JLink Error: Can not read register 15 (R15) while CPU is running ***JLink Error: Can not read register 16 (XPSR) while CPU is running ***JLink Error: Can not read register 0 (R0) while CPU is running ...
JLINK_IsHalted() returns FALSE (0002ms, 0504ms total)--- 是否开启了看门狗 导致复位、、 ......
***WARNING: CPU could not be halted*** *** Error: Can not read register 16 (XPSR) while CPU is runningCan not read register 20 (CFBP) while CPU is runningCan not read register 0 (R0) while CPU is runningCan not read register 1 (R1) while CPU is runningCan not read register ...
*** Error: CPU is not halted***WARNING: CPU could not be halted*** Error: Can not read register 15 (R15) while CPU is running*** Error: Can not read register 16 (XPSR) while CPU is running*** Error: Can not read register 13 (R13) while CPU is r...