irq_num=gpio_to_irq(6); res=request_irq(irq_num,get_state,IRQF_DISABLED,"buttons",(void *)buf); if(res<0) { printk("request irq failed!\n"); return -EIO; } set_irq_type(irq_num, IRQ_TYPE_LEVEL_LOW); Would you please give me some suggestions about how to request irq by gp...
kernel: tg3 0000:01:00.1: PCI INT B -> GSI 38 (level, low) -> IRQ 38 kernel: tg3 0000:01:00.1: setting latency timer to 64 kernel: tg3 0000:01:00.1: (unregistered net_device): Cannot get nvram lock, tg3_nvram_init failed kernel: tg3 0000:01:00.1: phy probe failed, err ...
(irq = 18, base_baud = 1500000) is a IMX [ 0.204964] printk: console [ttymxc1] enabled [ 1.633687] imx8mp-ldb ldb-display-controller: Failed to create device link (0x180) with 32e90000.lcd-controller [ 1.649203] loop: module loaded [ 1.654174] megasas: 07.725.01.00-rc1 ...
pin A routed to IRQ 135 NUMA node: 0 Region 0: Memory at f5800000 (64-bit, prefetchable) [size=8M] Region 3: Memory at f6808000 (64-bit, prefetchable) [size=32K] Expansion ROM at f2180000 [virtual] [disabled] [size=512K] Capabilities: [40] Power Management ver...
Trying to set irq flags for IRQ407 OMAP clockevent source: GPTIMER1 at 27000000 Hz Console: colour dummy device 80x30 Calibrating delay loop... 986.31 BogoMIPS (lpj=4931584) pid_max: default: 32768 minimum: 301 Security Framework initialized ...
imx-gpc 20dc000.gpc: failed to get clk! imx-gpc: probe of 20dc000.gpc failed with error -2 Switching to clocksource mxc_timer1 NET: Registered protocol family 2 TCP established hash table entries: 8192 (order: 4, 65536 bytes)
environment [root@node39 systemd]# uname -a Linux node39 3.10.0-957.el7.x86_64 #1 SMP Thu Nov 8 23:39:32 UTC 2018 x86_64 x86_64 x86_64 GNU/Linux [root@node39 systemd]# cat /etc/redhat-release CentOS Linux release 7.6.1810 (Core) [root@no...
Kernel Version 5.15.153.1-2 Distro Version Ubuntu 24.04 Other Software No response Repro Steps Upgrade Ubuntu 22.04 to Ubuntu 24.04 withdo-release-upgrade Expected Behavior Everything works fine, systemd services would start as before. Actual Behavior ...
I think there is a script that run on the first boot to extend SD card and create a user and maybe some other action. So the question is do a need to install armbian on a sdcard and do a first boot then copy the root FS. ...
AR6K_IRQ_PROC_REGS_SIZE, HIF_RD_SYNC_BYTE_INC,NULL);if(A_FAILED(status)) { AR_DEBUG_PRINTF(ATH_DEBUG_ERR, ("DumpAR6KDevState : Failed to read register table (%d) \n",status));return; } DevDumpRegisters(pDev,&procRegs,®s);if(pDev->GMboxInfo.pStateDumpCallback !=NULL) {...