With the enablement of PAgP, the two possible methods of link determination are preserve order and maximize load balancing between the links on the Fast EtherChannel. TheWhat Is PAgP and Where Do You Use It?section of this document describes PAgP. The default is to maximize load balancing. PA...
and it supports the below load-balancing methods show etherchannel load-balance EtherChannel Load-Balancing Configuration: src-dst-ip EtherChannel Load-Balancing Addresses Used Per-Protocol: Non-IP: Source XOR Destination MAC address IPv4: Source XOR Destination IP address IPv6: Source XOR Destination...
and it supports the below load-balancing methods show etherchannel load-balance EtherChannel Load-Balancing Configuration: src-dst-ip EtherChannel Load-Balancing Addresses Used Per-Protocol: Non-IP: Source XOR Destination MAC address IPv4: Source XOR Destination IP address IPv6: Source XOR Destination...
EtherChannel load-balancing options There are two load balancing methods for outgoing traffic in EtherChannel, as follows: round-robin, which spreads the outgoing traffic evenly across all of the adapters in the EtherChannel; and standard, which selects the adapter using an algorithm. ...
Different load-balancing methods have different advantages, and the choice of a particular load-balancing method should be based on the position of the switch in the network and the kind of traffic that needs to be load-distributed. Figure 3. Lo...
EtherChannel load-balancing options There are two load balancing methods for outgoing traffic in EtherChannel, as follows: round-robin, which spreads the outgoing traffic evenly across all of the adapters in the EtherChannel; and standard, which selects the adapter using an algorithm. ...
Load Balancing and Forwarding Methods(负载平衡和转发方法) 以太网通道负载均衡可以使用 MAC 地址或 IP 地址,源或目标地址,或同时使用源或目标地址。被选 择的模式适用于交换机上配置的所有以太网通道。通过使用 Port-channel Load-Balance 全局配置命 令来配置负载均衡和转发方法。 以源 MAC 地址转发,当数据包被...
Many methods can be used here. By default, the “src-dst-ip” (source and destination IP address) method is used for Layer 3 switching. Let’s take an example to understand more about this method. In the topology above, Switch1 uses the “src-dst-ip” method to load balancing traffic...
Load balancing is possible between the links that are part of the same EtherChannel. Depending on the hardware platform, you can implement one or several methods, such as source-MAC to destination-MAC or source-IP to destination-IP load balancing across the physical links. Keep in mind that ...
Of the three available methods, this is the preferred one to use. EtherChannel Protocols – PAgP Next one we have is PAgP, which is Cisco's Proprietary Port Aggregation Protocol. This works similarly to LACP where the switches on both sides negotiate the port channel creation and maintenance....