然后,发出以下命令:test etherchannel load-balance interface port-channel number {ip | l4port | mac} [source_ip_add |source_mac_add| source_l4_port] [dest_ip_add |dest_mac_add| dest_l4_port]。 下面列举了一些示例: 6509#remote login switchTrying Switch ... Entering CONSOLE for Switch Typ...
6500-sp#show etherchannel load-balance EtherChannel Load-Balancing Configuration: src-dst-ip mpls label-ip 查找为所需流之间的数据包选择的RBH值。 6500-sp#test etherchannel load-balance interface port-channel 在本例中,流量介于192.168.1.1到172.16.1.1之间,所讨论的端口通道为port-channel 1。根据步...
As far as I know, L2 or L3 etherchannel should cause no difference in the load balancing algo. The load balancing should depend only on the kind of traffic coming in. The ethertype in the frame should help in identifying the mpls traffic. So the loadbalancing should be according to what ...
Jim brings up an interesting point about whether flow mapping to Etherchannel ports is always deterministic (assuming all parameters are the same). As he correctly notes it may not be, although probably is on the lower end devices. Jim mentions polarization as being a factor why it may not ...
9300-STACK#sh etherchannel load-balance EtherChannel Load-Balancing Configuration: src-dst-mixed-ip-port EtherChannel Load-Balancing Addresses Used Per-Protocol: Non-IP: Source XOR Destination MAC address IPv4: Source XOR Destination IP address and TCP/UDP (layer-4) port number ...
EtherChannel load balancing can use MAC addresses or IP addresses, source or destination addresses, or both source and destination addresses. The mode applies to all EtherChannels that are configured on the switch. You configure the load balancing and forwarding method with use of theport-channel...
Information About Configuring IEEE 802.3ad Link Bundling and Load Balancing Gigabit EtherChannel Port Channel and LACP-Enabled Interfaces IEEE 802.3ad Link Bundling Benefits of IEEE 802.3ad Link Bundling LACP Enhancements Introduced in Cisco IOS Release 12.2(33)SB EtherChannel Load Balancing LACP Singl...
EtherChannel load-balancing can use several methods of load balancing that include MAC addresses or IP addresses, source or destination addresses, or both source and destination addresses. The selected mode applies to all EtherChannels configured on the...
Load Balancing EtherChannel can balance the traffic load across the links in the channel by reducing part of the binary pattern formed from the addresses or ports in the frame to a numerical value that selects one of the links in the channel. To balance the load, EtherChannel uses ...
Hi Vikram it is src-MAC and dst-MAC, with source-MAC address forwarding, when packets are forwarded to an EtherChannel, the packets are distributed across the ports in the channel based on the source-MAC address of the incoming packet. Therefore, to