We provide two calibration files to be used depending on your application. - For stereo system (e.g. 2ch dirac live, single speaker measurement), use the 0deg file and point the UMIK-1 at the speakers - For multichannel system (E.g. 5.1/7.1) or a surround application where multiple sp...
In the screenshot above, the name of a UMIK-1 calibration file is shown. Initially, however, this will be blank, so you will need to load the calibration file to the iPad and select it. Click on the Calibration File link and then on the Files link at the bottom right. This will br...
All UMIK-1 are calibrated with a unique calibration file. In addition, a unique auto-generated 90-degree calibration file for use with the nanoAVR DL is provided. To download the calibration files, look for the 7 digit Serial Number found on the body of the microphone. ...
You loose automatic calibration that way. Absolutely correct - in fact it will start polar pattern lobing an octave lower than a 1/4" capsule, and 2 octaves lower than an 1/8" capsule. I'm rather surprised that they did not go with MEMS "capsules" as they could get far more ...
Each UMIK has its own unique calibration files, which is why the serial number must be entered. 3. Set sample rates [Top] Set the input and output devices to the sample rate that you want to use. If you are using a UMIK-1, set the output device to 48 kHz. (The UMIK-1 can ...
1. Get your calibration files 2. Get connected 3. Set sample rates 4. Configure 5. Test 6. Measure What's next? 1. Get your calibration files [Top] Go to the UMIK-1 or UMIK-2 page and enter your microphone's serial number. It is in the form xxx-yyyy and labeled on the microph...
On the Mic config tab, select the UMIK-1. Click on the Load File button and locate the unique microphone calibration file that you downloaded from the UMIK-1 webpage.3. Set levelsOn the Output and levels tab, set the output volume to low. Click on the Test button for the left ...
The UMIK-1/2 will now appear as an interface inside the GUI. If you haven't done so already, now is the time to grab the unique calibration file for your microphone. Use the serial number on the body of the microphone to download the files from the UMIK-1/UMIK-2 product page. We...
1 x mini Tripod + Mic Clamp 1 x wind screen Unique Calibration File Download All UMIK-2 are calibrated with a unique calibration file. In addition, a unique auto-generated 90-degree calibration file. To download the calibration files, look for the 7 digit Serial Number found on the body ...