in cisco switches the command switchport trunk allowed vlan all is the default when you configure a port as a trunk so it is enogh to use int gi1/1/3 switchport mode trunk on both sides of the link using a port-channel if possible is recommended. in case LACP is far better then unco...
Cisco三层交换机端口设置trunk方法 Command rejected: An interface whose trunk encapsulation is "Auto" can not be configured to "trunk" mode. 问题症状: Switch(config-if)#switchport mode trunk Command rejected: An interface whose trunk encapsulation is "Auto" can not be configured to "trunk" mode....
The reason those requirements exists is because in any other configuration DTP will negotiate the link as a trunk-port and then it's no longer an access-port assigned to a specific VLAN - that would make the configuration without trunk-port not work...but then again, when you assign the ...
This is the command that configures the port of the switch in Access Mode. It is used to connect single hosts to the port such as user computers, servers, network printers etc. If a switch port is operating in “access” mode, it can be assigned to only a single VLAN, adding additiona...
Yes i meant to "disconnect" the SFP/cable from the physical port on the Juniper, and then "insert" into the corresponding configured physical port on the Cisco 9300.. 0 Helpful Reply Flavio Miranda VIP 09-24-2024 09:09 AM @KMNRuser Allowed command does not change the tagging...
What is the function of the command switchport trunk native vlan 999 on a Cisco Catalyst switch? A. It creates a VLAN 999 interface. B. It designates VLAN 999 for untagged traffic. C. It blocks VLAN 999 traffic from passing on the trunk. D. It designates VLAN 999 as the default for ...
Command output was updated to show Local UUID and Remote UUID information. Cisco IOS XE Everest 16.5.1b Command output was updated to show AEAD_AES_256_GCM and AEAD_AES_128_GCM cipher suites under Local Crypto Suite and Remote Crypto Suite. Cisco IOS XE Release 16.11.1 Command output...
配置CISCO 3560 Trunk时出现的问题,在3550EI上想把一个端口配成TRUNK时提示"Commandrejected:Aninterfacewhosetrunkencapsulationis"Auto"cannotbeconfiguredto"trunk"mode"解决方法:一、设置encapsulation模式:如ISL或者
Just loaded up Packet Tracer 6.1 and was trying to turn a port into a trunk port. I am using a Cisco 3560 switch (layer 3) inside of PT. I type: en conf t int gig0/1 switchport mode trunk When I hit enter that is when I get the message: Command rejected: An interface whose ...
Apply the following commands to Cisco Switch command line: interface GigabitEthernet1/1 description VMware ESX - Trunk A - NIC 0 – Port Description switchport trunk encapsulation dot1q –ESX only supports dot1q and not ISL switchport trunk allowed vlan 100,200 –Allowed VLANs switchport mode ...