选择这个试试 设置为HW RESET后仍提示CANNOT ENTER DEBUG MODE。我手动将复位拉低,再下载也同样提示。
但是因为没有唤醒,程序想重新烧录都不行了,一直提示“Cannot Enter Debug Mode”或者“Cannot access...
st-info:errorwhileloadingsharedlibraries: libstlink.so.1: cannotopensharedobjectfile: No suchfileordirectory 运行一下sudo ldconfig可以解决问题 通过st-info 检查 会提示无法进入 SWD 模式 $ st-info --probe Failed to parse flashtypeor unrecognized flashtype Failed to enter SWD mode Found 1 stlink ...
PWR_EnterSTOPMode(PWR_Regulator_LowPower , PWR_STOPEntry_WFI);执行到这句出现那个对话框。
# [26.226977] mmc1: Problem switching card into high-speed mode! 3 Linux中低功耗代码分析 3.1 psci初始化 psci_dt_init()读取dts中psci的配置,并调用对应版本的初始化函数。比如“arm,psci-1.0”: psci_1_0_init() ->psci_0_2_init()
When I go out from debug session, I can't connect anymore to the micro-controller and I can't flash it anymore. I guess that because always when I power on the Hardware, the CPU goes directly in deep sleep mode. I have the issue as described in the scr...
HAL_PWR_EnterSLEEPMode 385 30.2.12 HAL_PWR_EnterSTOPMode 385 30.2.13 HAL_PWR_EnterSTANDBYMode 386 30.2.14 HAL_PWR_EnableSleepOnExit 386 30.2.15 HAL_PWR_DisableSleepOnExit 387 30.2.16 HAL_PWR_EnableSEVOnPend 387 30.2.17 HAL_PWR_DisableSEVOnPend 387 30.2.18 HAL_PWR_PVD_IRQHandler 387 ...
TDTS = Tck_tim TIM_TimeBaseStructure.TIM_CounterMode = TIM_CounterMode_Up; //TIM向上计数模式 TIM_TimeBaseInit(TIM3, &TIM_TimeBaseStructure); //根据指定的参数初始化TIMx的时间基数单位 TIM_ITConfig(TIM3,TIM_IT_Update,ENABLE ); //使能指定的TIM3中断,允许更新中断 //中断优先级NVIC设置 NVIC...
一、问题 在STM32F103VET6 使用 CMSIS-DAP 下载程序时提示Cannot access Memory和Cannot enter Debug Mode 二、原因 是硬件问题,测量芯片的VREF+只有0.9V,VDDA只有0.8V,而下面的焊盘测量出都有3.3V。是引脚虚焊了。 三、解决方法 重新焊接后能正常下载程序。
STM32CubeIDE is more suitable to debug RTOS. Can Cube monitor work with STM32 sleep mode? during sleep mode, the debug bloc is not able to access the memory and returns 0. So the tool can not be used during sleep mode. Can CubeMonitor and IDE debugging run at the same time? ...