The short answer is no. DHCP is required though but you could use any server. Even a Cisco switch will do. Later on we will look at assigning configuration files dynamically from the DHCP server which can’t in
I usually only have to do this on very small sites, or occasionally on the test bench. Most of the time we will have a server sat doing DHCP. The procedure below was carried out on a router, but the procedure is the same for a catalyst switch. By default DHCP is disabled, you have...
Add-DhcpServerv4MulticastExclusionRange Add-DhcpServerv4MulticastScope Add-DhcpServerv4OptionDefinition Add-DhcpServerv4Policy Add-DhcpServerv4PolicyIPRange Add-DhcpServerv4Reservation Add-DhcpServerv4Scope Add-DhcpServerv4Superscope Add-DhcpServerv6Class Add-DhcpServerv6ExclusionRange Add-DhcpServerv6Lease Ad...
interface g0/1 -LAN(to switch) CODE: !hostname Router!boot-start-markerboot-end-marker!!! no aaa new-model!!!ip dhcp excluded-address 192.168.1.1 192.168.1.99!ip dhcp pool LINEnetwork 192.168.1.0 255.255.255.0default-router 192.168.1.1dns-server 192.168.1.1lease 3!!!...
I messed things up and did a complete factory reset of the switch that set the IP of the switch to DHCP and an IP address of 192.168.1.zzz. I found a video that allowed me to use the Web interface to the switch and manually upload a short text file moving from a DHCP to a ...
Tests DHCP server configuration. Cleans up configuration on Windows DHCP server that is related to Lync Server. Only the 64-bit version of DHCPUtil is included with Lync Server. Tip To use DHCPUtil with a 32-bit version of DHCP Server, do the following: ...
Setting Up VLAN Support Setting Up the PPCs Note For all of the commands you can issue on the PPC with the WSG, see the Cisco Service and Application Module for IP User Guide. Single-Entity Configuration WSG Release 1.2 and above supports a single point of configuration and a ...
To use DHCP, select Yes, or to set a static IP, select No, and then hit Enter. When setting it manually, you'll probably want to use the default subnet mask of 24 (meaning 255.255.255.0) and enter your router's IP for the default gateway and DNS server. Because you're likely on...
snmp-server community "public" unrestrictedvlan 1 name "DEFAULT_VLAN" untagged 1-52 ip address dhcp-bootp exitvlan 2 name "Voice" no ip address exit (The stacks are joined via an up link on port 49 of both switches.) The Draytek router: see attached. Port 1 on ...
Dhcp: Exempt DHCP, for both IPv4 and IPv6, protocol traffic. This option is available on computers that are running Windows® 7 or nextref_server_7. The default value when managing a local computer that is running Windows® 7 or nextref_server_7 is NeighborDiscovery,Dhcp. The default ...