修改klipper_z_calibration下的z_calibration.py内calibrate_z函数,如果最开始没有使用安装脚本而是直接复制的文件,则修改klippy/extras/z_calibration.py文件。之后记得要重启一次树莓派。 修改y_offset为0,一般在probing.cfg文件内。 修改switch_offset为一个比较大的值如1,在z_calibration.cfg文件内。 换上klicky ...
So yes, we really are aiming to calibrate it so that Z=0 is nozzle just touching the bed, not so that the nozzle is one layer-height away from the bed. The slicer will manage the layer heights for you automatically. However, it's often easier to just get it close enough with the ...
BTW, I made the adxl345 to self-calibrate its freefall acceleration offset, so it will no longer depend on the correctaxes_mapparameter. And now other adxl345s (besides the one that is used as a probe) can be (again) connected on-demand. Also if the probe was disconnected and then re...
_KlackDebug msg="probe_calibrate Axis homed" _CheckProbe action=query G90 Attach_Probe back=1 _KlackDebug msg="probe_calibrate calling klipper probe_calibrate" _Center_Probe _PROBE_CALIBRATE {% for p in params %}{'%s=%s ' % (p, params[p])}{% endfor %} M118 moving ...
ANSWER / SOLUTION was supplied by @xblax here: #224 (comment) What follows is the original thread in its entirety: When the Klipperscreen macro for Z calibrate is done, it remarks out (comments out) the original default -0.25 value in a ...
I agree that this could potentially be a hardware or OS issue - but since raspberry pis are probably the most common used platform that Klipper is run on, it might be worth collecting a few more hints or work-arounds to possibly add to the documentation or FAQ if confirmed... If it ...
Hi So this wired bug is only happens while doing a probing operations with BDsensor not mesh or calibrations. HW: Voron trident 350mm BTT M8P Klipper Version: v0.12.0-61-gb50d6669 BTT EBB36 1.2, Klipper Version: v0.12.0-61-gb50d6669, CAN...
Send the command PROBE_EDDY_CURRENT_CALIBRATE_AUTO CHIP=btt_eddy Follow the prompts on the klipper UI to lower the nozzle until it sandwiches a piece of paper between it and the bed but be careful not to dig into the bed. The paper should still be able to move with some force applied...
修改klipper_z_calibration下的z_calibration.py内calibrate_z函数,如果最开始没有使用安装脚本而是直接复制的文件,则修改klippy/extras/z_calibration.py文件。之后记得要重启一次树莓派。 修改y_offset为0,一般在probing.cfg文件内。 修改switch_offset为一个比较大的值如1,在z_calibration.cfg文件内。