NL_SET_ERR_MSG(extack, "Nexthop has invalid gateway"); goto out; } nh->fib_nh_scope = res.scope; nh->fib_nh_oif = FIB_RES_OIF(res); nh->fib_nh_dev = dev = FIB_RES_DEV(res); if (!dev) { NL_SET_ERR_MSG(extack, "No egress device for nexthop gateway"); goto out; ...
error: nexthop has invalid gateway. 文心快码BaiduComate 在处理“error: nexthop has invalid gateway”这类错误时,由于这通常是一个网络配置问题,而不是直接涉及编程代码,我将按照您提供的提示来分析和解答。 1. 确认错误信息的上下文 首先,这个错误通常出现在配置路由或网络转发规则时。可能是在配置静态路由、路...
Red Hat Enterprise Linux (RHEL) iproute Issue Unable to add gateway using ip route Error getting while adding gateway,Error: Nexthop has invalid gateway. Resolution Check the IP address and subnet mask of the network interface, and make sure thegateway IP addressis within thesame subnet. Refer...
Error: Nexthop has invalid gateway. davidassigbi@hp-elitebook:~$ ip a show mybridge 4: mybridge: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000 link/ether ba:5a:99:6e:19:87 brd ff:ff:ff:ff:ff:ff inet 192.168.1.5/24 brd 192.168.1.255 s...
其他目的地的数据包,经过eth1送往gateway 9.aaa.164.1,9.aaa.164.1就是我们在网络配置中所设置的“默认网关” 下面实践【配置路由表table 10】并【让路由规则使用table 10】 [root@VM-165-116-centos~]# ip routeadddefaultvia192.168.1.254table10Error:Nexthophas invalid gateway.[root@VM-165-116-centos~]...
If I try to add the gateway manually, I get this error: Code: # ip route add 123.123.123.112 dev ens18 # ip route add default via 123.123.123.112 dev ens18 Error: Nexthop has invalid gateway. What am I missing here? Does it have something to do with the IP address being one aft...
/sbin/ip route add 213.152.188.73/32 via 192.168.56.254 Error: Nexthop has invalid gateway. Sat Nov 12 00:32:07 2022 ERROR: Linux route add command failed: external program exited with error status: 2 Expected Behavior The ip route command to succeed ...
{$_.InterfaceDescription -like "*Wireless-AC 8265*"} $ipv4 = $defaultgatway.IPv4DefaultGateway.NextHop route add -p 0.0.0.0 mask 0.0.0.0 $ipv4 这句就直接提示错误 之前是报参数错误 后面改了下是直接提示route的help说明 但是这几句话 我如果开启一个powershell 然后一句句粘贴执行 又不报错 是不...
Verify that R1 (headend) has no visibility to R6 loopback address. Device# sh ip route 192.168.0.1 % Network not in table Verify that VRF prefix is injected via MP-BGP in R1 VRF SR routing table. Device# sh ip route vrf sr