Enter the CLI of the quorum server and run the sudo ufw status command in any directory to check whether the firewall configuration has taken effect. If 30002/tcp ALLOW Anywhere and 30002/tcp(v6) ALLOW Anywhere (v6) are displayed in the command output, the firewall configuration has taken ...
格式的配置文件（位于/etc/netplan），生成 NetworkManager 或 systemd-network 所需要的配置文件，用于配置网络。Ubuntu从17.10起，就使用netplan代替了之前的ifupdown的linux系统默认的网络管理工具。之前的网络配置，常编辑 /etc/network/interfaces文件，并重启网络服务；netplan的引入，使得网络配置更方便。
1. ubuntu18.04配置静态ip 注意： 18.04和16.04不一样了，配置静态ip的方法有很大差异！ 查找netpl...
With IPv6, further nexthops may be appended to the same route via ip route append command. scope SCOPE_VAL the scope of the destinations covered by the route prefix. SCOPE_VAL may be a number or a string from /usr/share/iproute2/rt_scopes or /etc/iproute2/rt_scopes (has precedence...
I used all the settings that worked previously Identity: Gateway, User Authentication Type: Password, NT Domain L2TP IPsec Options: Type: Pre-shared key (PSK), Pre-shared key, Advanced settings left as default L2TP PPP Options: only checked PAP (unckecked CHAP, MSCHAP, MSCHAPv2, EAP), ...
xrandr-scaling: Never try to set invalid screen sizes (again!) Looks like this change (introduced to fix 1889090) got lost while rebasing previous fixes, gbp has been a bad guy this time! mutter 1896332 Merge with debian, containing new stable release mutter 1892440 Don't set the font-...
network segment. In other words, the nexthop must be the target, or you will have to configure the nexthop to forward it further if so desired. --gateway ipaddr Send the cloned packet to the host reachable at the given IP address. Use of 0.0.0.0 (for IPv4 packets) or :: (IPv6)...
() - net: dsa: bcm_sf2: Call setup during switch resume - net: hns: fix for unmapping problem when SMMU is on - net: ipv4: update fnhe_pmtu when first hop's MTU changes - net/ipv6: Display all addresses in output of /proc/net/if_inet6 - netlabel: check for IPV4MASK in ...
() - net: dsa: bcm_sf2: Call setup during switch resume - net: hns: fix for unmapping problem when SMMU is on - net: ipv4: update fnhe_pmtu when first hop's MTU changes - net/ipv6: Display all addresses in output of /proc/net/if_inet6 - netlabel: check for IPV4MASK in ...
Enter the CLI of the quorum server and run the sudo ufw status command in any directory to check whether the firewall configuration has taken effect. If 30002/tcp ALLOW Anywhere and 30002/tcp(v6) ALLOW Anywhere (v6) are displayed in the command output, the firewall configuration has taken ...