rack and pinion mounts to clear the pan. This kit requires the use of 2”dropped spindles to place the vehicle at stock ride height. Place the vehicle on the ground and align the front end using the following settings:Caster: 1° positive Camber: 1/2° positive Toe-In: 1/8” +/- 1...
Power rack and pinion Front sway bar Sub-frame connectors 4-wheel disc brakes 17” front/18” rear Shelby-American Racing wheels Full roller 351 engine -500 HP Trick Flow aluminum heads Edelbrock aluminum intake March Pulleys and brackets ...
both ends of the rack and pinion. Helix has these extensions available. (Part number HEXRACKEX2.) Use one 2” extension on either side of the rack to maintain the correct geometry of the crossmember. Position the vehicle at the desired finished ride angle and set the caster, camber and ...
Inside it is a little more difficult as the 5.0 cable has a small end and the ’69 had a large barrel end. I took a piece of small pipe that fit the curve of the connection, made a cross cut and then a vertical cut allowing the cable to slice over and down into a position keepi...