SET_EXTRUDER_ROTATION_DISTANCE EXTRUDER=t{Tool} DISTANCE={rd_original0 - 1.5 } ##则设置电机T1的脉冲 DISTANCE为num UPDATE_DELAYED_GCODE ID=fastkeep DURATION=5 ##更新buffer的延时数据(DURATION)数据 {% else %} SET_EXTRUDER_ROTATION_DISTANCE EXTRUDER=t{Tool} DISTANCE={rd_original0} #恢复原始值 ...
Do proper calibration with filament before use. If 'DISTANCE' value is not provided then this command will return the current rotation distance. SYNC_EXTRUDER_MOTION SYNC_EXTRUDER_MOTION EXTRUDER=<name> MOTION_QUEUE=<name>: This command will cause the stepper specified by EXTRUDER (as defined...
https://www.klipper3d.org/Rotation_Distance.html For this I heated the nozzle so I could unscrew it. Removed filament. Turned of the heat. Made a fresh cut in the filament and re-inserted it and moved it by hand all the way though the extruder. Marked the filament at the extruder ent...
## Update value below when you perform extruder calibration ## If you ask for 100mm of filament, but in reality it is 98mm: ## rotation_distance = <previous_rotation_distance> * <actual_extrude_distance> / 100 ## 22.6789511 is a good starting point rotation_distance: 22.6789511 #...
## Update value below when you perform extruder calibration ## If you ask for 100mm of filament, but in reality it is 98mm: ## rotation_distance = <previous_rotation_distance> * <actual_extrude_distance> / 100 ## 22.6789511 is a good starting point rotation_distance: 22.6789511 #...
However, without a feedback system, the 2 extruders may gradually drift out of sync from even a small mismatch in how well their rotation_distance calibrations match the actual movement ratios. Longer prints will build up to a larger mismatch, which may add extra resistance to the filament's...
Axis rotation distance: 4 mm Probing speed: 3 mm/s Possible Solutions Investigate whether the code currently applies the difference between halt_pos and trigger_pos to stepper state that already reflects halt_pos and not trigger_pos. Evaluate the necessity of the current endstop oversampling appro...
SET_EXTRUDER_ROTATION_DISTANCE EXTRUDER=t{Tool} DISTANCE={rd_original0 - 1.5 } ##则设置电机T1的脉冲 DISTANCE为num UPDATE_DELAYED_GCODE ID=fastkeep DURATION=5 ##更新buffer的延时数据(DURATION)数据 {% else %} SET_EXTRUDER_ROTATION_DISTANCE EXTRUDER=t{Tool} DISTANCE={rd_original0} #恢复原始值...
Essentially all of these provide a feedback signal (the first two lacking a neutral space and so are always working) that dynamically changes the rotation_distance of the gear (filament driver) stepper. When extruding and the sync feedback sensor reports tension, the sync_multiplier_low is used...
SET_EXTRUDER_ROTATION_DISTANCE EXTRUDER=t{Tool} DISTANCE={rd_original0 - 1.5 } ##则设置电机T1的脉冲 DISTANCE为num UPDATE_DELAYED_GCODE ID=fastkeep DURATION=5 ##更新buffer的延时数据(DURATION)数据 {% else %} SET_EXTRUDER_ROTATION_DISTANCE EXTRUDER=t{Tool} DISTANCE={rd_original0} #恢复原始值...