The heated bed will remain heated for the time set by `timeout_pause` The extruder will remain hot for the time set with `disable_heater` To proceed you need to address the specific issue. You can move the filament by hand or use basic MMU commands. Once you think you have things cor...
So, even if input_shaper was running for a very long time, it should not have stopped the PID from updating. (The input_shaper C code does not block the Python PID code.) FYI, I've been chasing down a possible interaction with the Python garbage collector, which could cause the PID ...
The heated bed will remain heated for the time set by `timeout_pause` The extruder will remain hot for the time set with `disable_heater` To proceed you need to address the specific issue. You can move the filament by hand or use basic MMU commands. Once you think you have things cor...