additionally it appeared to remove klipper.service. moonraker was still running but not doing much. had a backup so deleted my /home/pi/* and started a fresh kiauh and will try another install without my own config. note your config examples do not appear to cover ender 5 pro 4.2.2 boa...
See examples here:https://gitlab.com/pipettin-bot/forks/firmware/klipper-stack/-/tree/pipetting/printer_data/config These are meant assoftreference configs; youmustadjust them to match your setup before using them. Pin mappings for the Arduino CNC-Shield (v3.0) have been added to this repo...
github: Fix cron entry in close-invalid-bot.yaml 4年前 config docs: Prefer Jinja2 "set" directive to default_parameter_xxx in examples 4年前 docs docs: Move palette2 location in Config_Reference.md 4年前 klippy probe: Use original XY position on multiple probe samples ...
I have the Duet WiFi and Duex5 boards. I've installed Klipper and everything works except the bl touch. The bl touch does its system check moving up and down and I have a solid red light. The debug pin down command doesn't move the pin down. Pushing the pin up or down the probe...
/// demo configis #ifndef LV_EX_CONF_H #define LV_EX_CONF_H /*** * GENERAL SETTING ***/ #define LV_EX_PRINTF 1 /*Enable printf-ing data in demoes and examples*/ #define LV_EX_KEYBOARD 1 /*Add PC keyboard support
What you can do is add the config examples for the various boards with the pins exposed to the documentation exactly as it is done for the mcu. ( Kevin allowing volunteers to be accepted;) ) ... I don't have any /dev/gpiochip* device in armbian like in raspios, maybe somthing in...
Config_Changes.md Config_Reference.md Config_checks.md Contact.md Debugging.md Delta_Calibrate.md Eddy_Probe.md Endstop_Phase.md Example_Configs.md Exclude_Object.md FAQ.md Features.md G-Codes.md Hall_Filament_Width_Sensor.md Installation.md Kinematics.md MCU_Commands.md Manual_Level.md Me...
To install the macros, first clone this repository inside of your printer_data/config directory with the following command. git clone https://github.com/jschuh/klipper-macros.git Then paste the below sections into your printer.cfg to get started. Or even better, paste all of it into a se...
Am not at home right now so no access to my config file but it is explained in the docs and config examples. Collaborator KevinOConnor commented Jun 7, 2018 I'm aware that @chainsol reported a similar issue with the bltouch not deploying properly. I don't have a bltouch, so I ...
Add the macros.cfg to your printer config. Components Multi fan - multiple primary part fans. Toolchanger - tool management support. Tool probe - per tool Z probe. Rounded path - rounds the travel path corners for fast non-print moves. Tools calibrate - support for contact based XYZ offset...