jlink info: failed to power up dap 错误表明J-Link调试器无法为目标硬件(DAP,即Debug Access Port)提供电源或无法正确与其通信。 检查J-Link与目标硬件的物理连接: 确保J-Link调试器与目标硬件之间的连接正确无误。检查所有连接线是否牢固,没有松动或损坏。 检查目标硬件上的DAP接口是否有物理损坏。 检查目标硬...
I am working on a custom development board that is using the nRF52840. After programming the nRF52840 on the board with Soft Device s140_nrf52_7.0.1_softdevice.hex from the NRF5x SDK 16.0.0, I can no longer connect to the chip using a JLink Ultra or a PCA10056 dev b...
* JLink Info: Failed to power up DAP * JLink Info: Found SW-DP with ID 0x6BA02477 * JLink Info: DPIDR: 0x6BA02477 * JLink Info: CoreSight SoC-400 or earlier * JLink Info: Scanning AP map to find all available APs * JLink Info: AP[0]: Stopped AP scan as end of...
Iterating through AP map to find AHB-AP to useAP[0]: Skipped. Could not read CPUID registerAP[1]: Skipped. Not an AHB-APAttach to CPU failed. Executing connect under reset.Failed to power up DAPConfigTargetSettings() startConfigTargetSettings() end - Took 18usInitTarget() ...
JLink Error: Communication timed out: Requested 20 bytes, received 0 bytes ! Could not transfer JTAG data. DAP error while reading DP-Ctrl-Stat register. Error: Flash Download failed - Target DLL has been cancelled. What means: Could not power-up debug power domain? How can I fix this ...
DEBUG probe_rs::probe::cmsisdap::tools: Attempting to open 1366:1080 in CMSIS-DAP v1 mode Error: Failed to open the debug probe. Caused by: 0: An error which is specific to the debug probe in use occurred. 1: device is not a J-Link device ...
Warn : couldnotclaim interface: Operationnotsupportedorunimplementedonthis platformError:errorwriting data:EntitynotfoundError: CMSIS-DAP command CMD_INFO failed. PS D:\Applications\eclipse\OpenOCD> 如前文所说,我使用的是 CMSIS-DAPv1, 但是 OpenOCD 使用的是 CMSIS-DAP v2 的接口,所以出现了找不到入...
Failed to power up DAPConfigTargetSettings() startConfigTargetSettings() end - Took 9usInitTarget() startUnknown SDA AP Id detected: 0xFFFFFFFFInitTarget() end - Took 401msCannot connect to target.J-Link> 【The following is the information displayed by Jlink Commander during...
SWO GetSpeedInfo Prints the available SWO speed and its minimum divider. waithalt Waits for target to halt code execution. wice Writes to given IceBreaker register. ReadAP Reads the specified CoreSight DAP-AP register. ReadAPEx Reads the specified CoreSight DAP-AP register. ReadMemAP Re...
Failed to power up DAPConfigTargetSettings() startConfigTargetSettings() end - Took 9usInitTarget() startUnknown SDA AP Id detected: 0xFFFFFFFFInitTarget() end - Took 401msCannot connect to target.J-Link> 【The following is the information displayed by Jlink Commander during normal opera...