the static route is invalid (the next hop address is all 0s or the IP address of the physical interface on the local device).该静态路由无效(下一个跳地址全0或者下一跳地址是本机物理接口IP地址)。 pim is disabled on the Oif. 出接口未使能PIM。 the instance of local-cross route Oif is ...
the static route is invalid (the next hop address is all 0s or the IP address of the physical interface on the local device).该静态路由无效(下一个跳地址全0或者下一跳地址是本机物理接口IP地址)。 pim is disabled on the Oif. 出接口未使能PIM。 the instance of local-cross route Oif is ...
ND DAD is enabled, number of DAD attempts 重复地址检测功能是否使能(该例中使能) 若处于使能状态则同时显示重复地址检测时发送邻居请求消息的次数(可通过ipv6 nd dad attempts命令进行配置) 若处于关闭状态则显示“ND DAD is disabled”(可通过配置重复地址检测时发送邻居请求消息的次数为0关闭该功能) ND reachab...
ND DAD is enabled, number of DAD attempts 重复地址检测功能是否使能(该例中使能) 若处于使能状态则同时显示重复地址检测时发送邻居请求消息的次数(可通过ipv6 nd dad attempts命令进行配置) 若处于关闭状态则显示“ND DAD is disabled”(可通过配置重复地址检测时发送邻居请求消息的次数为0关闭该功能) ND reachab...
When duplicate address detection identifies a duplicate address, the state of the address is set to DUPLICATE and the address is not used. If the duplicate address is the link-local address of the interface, the processing of IPv6 packets is disabled on the interface and an error SYSLOG ...
Next Header Value Description Hop-by-hop options header 0 Header that is processed by all hops in the path of a packet. When present, the hop-by-hop options header always follows immediately after the base IPv6 packet header. Destinatio...
also once this is run why does the next command show an output of route show that only includes the c008 route? scytocommentedSep 16, 2019• edited I have tried running this on the hosts to no avail: sudo sysctl net.ipv6.conf.ovs_eth0.accept_ra=2 ...
Enabling IPv6 Unicast Routing on the Switch The ipv6 unicast-routing command enables the forwarding of IPv6 unicast packets. When routing is enabled, the switch attempts to deliver inbound packets to destination addresses by forwarding them to interfaces or next hop addresses specified by the IPv6...
The following information is displayed on the Protocol tab:• DHCPv6 State: If the interface is configured for Stateless mode, the DHCPv6 State will be Stateless. If the interface is configured for Stateful mode, the DHCPv6 State will be either Enable or Disabled. When the interface is in ...
disabled Format no ipv6 route <ipv6-prefix>/<prefix_length> [{<next-hop-address> | interface <slot/port> <next-hop-address> | <preference>}] Mode Global Config ipv6 mtuThis command sets the maximum transmission unit (MTU) size, in bytes, of IPv6 packets on an interface. This...