针对您遇到的错误“Error: The IP address you entered overlaps with another interface!”,这里有一些步骤和建议,帮助您解决这个问题: 确认报错信息的含义和上下文: 这个错误表明您尝试配置的IP地址已经在另一个网络接口上被使用。在计算机网络中,每个IP地址必须是唯一的,以确保数据包的正确路由和传输。 检查网络配...
# 我想在g 1/0/1接口下配置ip,级联到上个设备,输入下面命令后提示已被使用,哪位大侠指点下,谢谢! [H3C-GigabitEthernet1/0/1]port link-mode route [H3C-GigabitEthernet1/0/1]ip add 192.168.220.2 24 提示:This subnet overlaps with another interface! 组网及组网描述: 交换机上先配置了 # inte...
apharmaceutical factory 配药工厂 [translate] aError: The IP address you entered overlaps with another interface! 错误: IP地址您输入交叠与另一个接口! [translate] 英语翻译 日语翻译 韩语翻译 德语翻译 法语翻译 俄语翻译 阿拉伯语翻译 西班牙语翻译 葡萄牙语翻译 意大利语翻译 荷兰语翻译 瑞典语翻译 希腊语...
路由器WAN设置多个同一网段的公网IPISP给了我多个公网IP地址,假设是1.1.1.1/29,1.1.1.1是网关...
A (*, G) entry is created hop by hop, and an RPT with the RP as the root is generated. Figure 4-9 RPT setup During RPT setup, PIM routers perform an RPF check before sending a Join message. Each router searches for a unicast route toward the RP, in which the outbound interface ...
Hi, You would probably need to look at subnetting the address range accordingly to fit in with your topology. E.g. if my ISP had given me the 123.123.123.0/24 range I may subnet it so that one interface had 123.123.123.1/30 and another may have
You would probably need to look at subnetting the address range accordingly to fit in with your topology. E.g. if my ISP had given me the 123.123.123.0/24 range I may subnet it so that one interface had 123.123.123.1/30 and another may have 123.123.123.5/30. Hope that helps Regards ...
# calico.ipip.crosssubnet.clab.ymlname: calico-ipip-crosssubnettopology:nodes:gw0:kind: linuximage: vyos/vyos:1.2.8cmd: /sbin/initbinds:- /lib/modules:/lib/modules- ./startup-conf/gw0-boot.cfg:/opt/vyatta/etc/config/config.bootbr-pool0:kind: bridgebr-pool1:kind: bridgeserver1:kind...
172.16.2.0 255.255.0.0 172.16.1.0 255.255.0.0 这两个在同一网段中。确实重叠了,你的子网掩码是255.255.0.0 说明你的前两个点分十进制表示的是网络位,但是你的这两个的ip地址的前两块都是一样的,所以在同一网段中,如果把子网掩码改为255.255.255.0就没有问题了 还有任何...