You may encounter a problem when assigning an IP address to an interface. If that IP address is already in use by another interface (for example, a remote VRRP interface), you may see the following message: Invalid configuration: this IP address overlaps with another interface in network Y...
The OSPF router ID of the connected router is the IP address of the connected interface. Answer: C 2. Refer to the exhibit. The network shown in the exhibit has just been installed. Host B can access the Internet, but it is unable to ping host C. What is the problem with this ...
For subnet 172.16.0.0/255.255.255.192 .0 is the network address and .63 is the broadcast address - that's why you cannot assign it to an interface. Same for 172.16.0.64/255.255.255.248 (.64 = network, .79 = broadcast) - in general first IP in the range is the network address, last...
Executing command: dhcpd address 192.168.10.5-192.168.10.254 inside Executing command: dhcpd enable inside Executing command: logging asdm informational <--- More --->ERROR: Failed to apply IP address to interface GigabitEthernet1/1, as the network overlaps with interface GigabitEthernet1/2....
ERROR: Address 202.100.100.6 overlaps with outside interface address.ERROR: NAT Policy is not downloaded谢谢。配置如下:PVSZ-FW(config)# show run: Saved: : Serial Number: JAD24020KY1: Hardware: ASA5516, 8192 MB RAM, CPU Atom C2000 series 2416 MHz, 1 CPU (8 cores):ASA Version 9....
Explanation There may be another router on this network that is configured with the same IP address. Recommended Action Check all routers on the interface for misconfiguration. Error Message ARP-2-DUP_STATIC: [chars] static exists for, IP=[chars], VLAN=[dec], IOD=[dec], I...
最佳答案不可以overlaps是重叠的意思路由器有 回答人的补充 2010-01-02 18:49 % 192.168.1.0 overlaps with FastEthernet0/0 意思是说f0/0口跟192.168.1.0网段重叠路由器有这么个规矩就是一台机器上 不同接口不能配置相同网段的IP地址 不然会提示失败路由器本来就是连接不同网路的接点设备你整个相同的iP段 那...
FMC >> failover interface ip folink 169.254.1.1 255.255.255.252 standby 169.254.1.2 FTD192.168.70.211 >> info : ERROR: Failed to apply IP address to interface GigabitEthernet0/5, as the network overlaps with interface Internal-Data0/1. Two interfaces cannot be in the same subnet. ...
Interface IP-Address OK? Method Status Protocol FastEthernet0/0 192.168.0.2 YES manual up up FastEthernet1/0 unassigned YES unset administratively down down R2(config)#interface f1/0 R2(config-if)#ip addres 192.168.0.3 255.255.255.0 % 192.168.0.0 overlaps with FastEthernet0/0 ...
第一部分:扩展ACL 拓扑图 地址表 Device Interface IP address R1 F 0/0 172.16.19.1 F 0/1 10.3.19.1 S 0/0/1 10.1.19.1 R2 S 0/0/1 10.1.19.2 S 0/0/0 10.2.19.2 R3 F 0/0