Use thenoip default-gatewayip-addresscommand to delete one default gateway. Use thenoip default-gatewaycommand to delete all default gateways. Example The following example defines default gateway 192.168.1.1. switchxxxxxx(config)#ip default-gateway192.168.1.1 show ip interface Use theshow...
The "ip default-gateway x.y.z.w" command is necessary in a Layer 2 switch to management remotely. Without this command, you can't access by telnet/ssh On Cisco press Configure the Default Gateway. The switch should be configured with a default gateway if the switch will be mana...
switchxxxxxx(config)# ip default-gateway 192.168.1.100 ip domain lookup To enable the IP Domain Naming System (DNS)-based host-name-to-address translation, use the ip domain lookup Global Configuration mode command. To revert to its default setting, use the no form of this command. Syntax...
Switch(config)# Interface fastethernet 0/1 ＃进入具体端口配置模式 Switch(config-if)#Switchport port-secruity ＃配置端口安全模式 Switch(config-if )switchport port-security mac-address MAC(主机的MAC地址)＃配置该端口要绑定的主机的MAC地址 Switch(config-if )no switchport port-security mac-a...
Situation: Unfortunately, I mistakenly selected a Nexus3000 series switch, only to discover that the "ip default next-hop" command does not function as expected. Despite having a default gateway configured in the main routing table, this command fails to operate on the Nexus3000 series...
2960 does not have "show ip route" as it is not multilayer switch but i have an option to input command "ip default-gateway x.x.x.x". About 3560-24PS, it does not have option to input "ip default-gateway x.x.x.x" but has an "show ip route" command. I searched a bit and...
Cisco 特殊VLAN划分之一个VLAN多个网段IP 1.拓扑如图所示. 2.连线示意如下: Switch1 F0/1 <---> Router1 F0/0 Switch1 F0/2 <---> Router2 F0/0 Switch1 F0/3 <---> Router3 F0/0 Switch1 F0/4 <---> Router4 F0/0 3.r01,r02,r03模拟PC。ip地址分别为:192.168.1.1;192.168.2.2;192.168...
Switch(config-if)#exit 二、配置DHCP地址池和相应参数 Switch(config)#ip dhcp pool Linux(建立名为Linux的地址池) Switch(dhcp-config)#network10.56.1.0255.255.255.0(网络地址) Switch(dhcp-config)#dns-server 8.8.8.8(DNS地址) Switch(dhcp-config)#default-router10.56.1.1(默认网关) ...
Client devices have a default gateway of the MX WAN appliance. The ports used to connect the MS switch and MX WAN appliance are both properly configured to allow traffic from VLANs 1 and 2 and are using the same native VLAN. How is traffic routed given the above configuration?
Switch(config)no Ip access-group IP in #清除名为IP的访问列表 在cisco交换机中为了防止ip被盗用或员工乱改ip,可以做以下措施,即ip与mac地址的绑定和ip与交换机端口的绑定。 一、通过IP查端口 先查Mac地址,再根据Mac地址查端口: bangonglou3#show arp | include 208.41 或者show mac-address-table 来查看...