Configure port-channel and some other port settings: Raw S4048-ON-sw(conf)#int range te1/2,te1/7 S4048-ON-sw(conf-if-range-te-1/2,te-1/7)#port-channel-protocol lacp S4048-ON-sw(conf-if-range-te-1/2,te-1/7-lacp)# S4048-ON-sw(conf-if-range-te-1/2,te-1/7-lacp)#por...
Components Used Background Information Configure Initial setup Configuration steps Verify Troubleshoot Related Cisco Support Community Discussions Introduction This document describes how to configure fast Link Aggregation Control Protocol (LACP) timer for port-channel in Cisco...
Adjust channel width Enable QoS settings for priority devices Update router firmware 4. Configure Advanced Features Additional settings to enhance your network: Set up Guest Network Create separate network for visitors Limited access to main network ...
In this case, run the port-isolate enable command on the Layer 2 interface of the AC to configure port isolation to isolate unnecessary broadcast and multicast packets. <Huawei> system-view [Huawei] sysname AC [AC] vlan batch 100 101 [AC] interface gigabitethernet 0/0/0 [AC-Gigabit...
how to configure multiple default gateways on ASA for diff. vlans Hi all, I am configuring cisco ASA 5525-x .I configured port-channel sub interfaces for multiple vlans. I also configured ASA as a dhcp server for these vlans. I created different dhcp scope for different vl...
Configure the switch. # Add GE0/0/1 and GE0/0/2 on the switch to VLAN 100, and set the default VLAN of GE0/0/1 to VLAN 100. <HUAWEI>system-view[HUAWEI]sysname Switch[Switch]vlan batch 100[Switch]interface gigabitethernet 0/0/1[Switch-GigabitEthernet0/0/1]port link-type trunk[...
Link Aggregation is referred to using different terminology by different vendors, including Port Channel, Ether Channel, Trunk, and Port Grouping. Link Aggregation LimitationsLink Aggregation only works with unassigned interfaces. SonicOS 6.5 introduces support for Dynamic Link Aggregation using Link Aggregat...
switch (config interface port-channel 1) # exit switch (config) # 3. Add interfaces to this LAG in either LACP active or LACP passive modes: switch (config) # interface ethernet 1/1 switch (config interface ethernet 1/1) # channel-group 1 mode active ...
Moreover, the Core Nexus switch is also connected to a border router with a pure Layer 3 Interface (Route Port) as we will see in the configuration below. MORE READING:Cisco Switch EtherChannel Configuration - LACP - PAgP Here are the VLAN and IP Subnet details of our network topology: ...
5. Configure Your WiFi Network: Log in using the default username and password (found in the router’s manual or on a sticker on the router). Navigate to the wireless settings section. Set your SSID (network name) and choose a strong network security key (WiFi password). ...