Components Used Background Information Configure Initial setup Configuration steps Verify Troubleshoot Related Cisco Support Community Discussions Introduction This document describes how to configure fast Link Aggregation Control Protocol (LACP) timer for port-chann...
I want to monitor the status of my port channels, which are (P), (I), (w), and so on. I want to monitor the status of the port on a Cisco switch. Is this possible? I found this OID: 1.3.6.1.4.1.9.9.285, but it is not found on all the switches and routers I tested...
Remote Devices (over the P2P VPN network) belong to a mobile 4G network and receive private IP Addresses with no access to Internet.We would like these devices to not only have access to our Organization network(s) - as the already do - but to also be able to access the Intern...
You need to make changes on the logical port-channel. And no, you don’t need to remove the port from the port-channel to make change like some people have suggested unless there was some inconsistency on your individual ports. - Grockin100 on Reddit Whoah... I did not...
SW1(config)#interface range fastEthernet 0/3-24, gigabitEthernet 0/1-2 SW1(config-if-range)#shutdown It’s all and enough to configure switch port security on this lab. Let’s test it. Part 2:Verify Port Security Try to test your switch port security configuration with ping command an...
How to configure SonicWall as a Bridgeowgo to Network>Interface. Configure X0 and X1 port. Design for setup SonicWall as Bridge behind Cisco ASAThey would like to add one SonicWall NSA 2400 to use these features: intrusion prevention, gateway anti-virus, and anti-spyware. ...
How to Configure Cisco Router using Console Cable To connect to the Router with the Console, you will need a Rollover cable. One end of this cable is RS-232, and the other end is RJ-45. The RJ-45 end connects to the console port of the Router, and the RS-232 end connects to the...
you also need to delete the port channel interface from the config. Deleting the command won't remove the port channel interface as well it just removes the interface from that channel group. Cheers LikeReply sarahanand Edited by Admin February 16, 2020 at 4:28 AM Wassamba, Just removing ...
you also need to delete the port channel interface from the config. Deleting the command won't remove the port channel interface as well it just removes the interface from that channel group. Cheers LikeReply sarahanand Edited by Admin February 16, 2020 at 4:28 AM Wassamba, Just removing ...
Note: it is not supported to configure a QoS policy under port-channel interfaces, only under the physical interfaces part of the port-channel ASR-920-1(config)#interface port-channel 2 ASR-920-1(config-if)#service-policy output qos-tac ...