If the shock body retracts into the air sleeve near bottom-out after the air is released from the positive chamber, attach a FOX high pressure pump and pressurize the shock to 250psi (17 bar). If the shock does not fully extend, it is in a "stuck down" condition. ...
FOX 潜力 X 悬挂式车座摆动调节指南说明书
If the shock body retracts into the air sleeve near bottom-out after the air is released from the positive chamber, attach a FOX high pressure pump and pressurize the shock to 250psi (17 bar). If the shock does not fully extend, it is in a "stuck down" condition. ...
Step 1 To best maintain the performance and durability of your product under normal use, FOX recommends that you have regular fork and shock maintenance performed according to the service intervals listed below. *Suspension product will require more frequent servicing the harder they are worked.For ...
If the shock body retracts into the air sleeve near bottom-out after the air is released from the positive chamber, attach a FOX high pressure pump and pressurize the shock to 250psi (17 bar). If the shock does not fully extend, it is in a "stuck down" condition. ...
If the shock body retracts into the air sleeve near bottom-out after the air is released from the positive chamber, attach a FOX high pressure pump and pressurize the shock to 250psi (17 bar). If the shock does not fully extend, it is in a "stuck down" condition. ...
FLOAT X2 shocks have a maximum pressure of 300psi (17.2 bar)NOTE: Pressure measured at an ambient temperature of 70-75ËšF. Normal operating temperature range for FOX products is 20-140ËšF.Step 1 Sag should be set to ~30% of total shock travel To achieve the best performance ...
WARNING: FOX products should be serviced by a qualified bicycle service technician, in accordance with FOX specifications. If you have any doubt whether or not you can properly service your FOX product, then DO NOT attempt it. Improperly serviced products can fail, causing the rider to lose con...
2017 36 FLOAT maximum air pressure is 125psi 2017 36 TALAS maximum air pressure is 200psi Depending on variables such as riding style, terrain, bike geometry, etc, you may find that you can only achieve proper sag and ride performance with up to 10psi over or under the recommended value ...
Clamp the Upper Post in your bike work stand, then slowly unthread the bleed screw to release IFP pressure. Remove the screw from the Sealhead with a 1.5mm hex wrench. The bleed screw is the M3 screw that is farthest from the two blind holes in the Sealhead. Make sure that all press...