FLOAT X2 Air Spring Volume Spacers each have a volume of 0.25³ (PN: 233-00-240). Never install more than the maximum number of air volume spacers listed in the chart above. WARNING: Do not remove the internal red spacer limiter and under no circumstances use more than the Fox Fac...
FOX 潜力 X 悬挂式车座摆动调节指南说明书
If the shock body retracts into the air sleeve near bottom-out after the air is released from the positive chamber, attach a FOX high pressure pump and pressurize the shock to 250psi (17 bar). If the shock does not fully extend, it is in a "stuck down" condition. ...
WARNING: FOX suspension products contain pressurized nitrogen, air, oil, or all 3. Suspension misuse can cause property damage, SERIOUS INJURY OR DEATH. DO NOT puncture, incinerate or crush any portion of a FOX suspension product. DO NOT attempt to disassemble any portion of a FOX suspension ...
If the shock body retracts into the air sleeve near bottom-out after the air is released from the positive chamber, attach a FOX high pressure pump and pressurize the shock to 250psi (17 bar). If the shock does not fully extend, it is in a "stuck down" condition. ...
FLOAT X2 Air Spring Volume Spacers each have a volume of 0.25³ (PN: 233-00-240). Never install more than the maximum number of air volume spacers listed in the chart above.WARNING: Do not remove the internal red spacer limiter and under no circumstances use more than the Fox Facto...
If the shock body retracts into the air sleeve near bottom-out after the air is released from the positive chamber, attach a FOX high pressure pump and pressurize the shock to 250psi (17 bar). If the shock does not fully extend, it is in a "stuck down" condition. ...
Repeat steps 2-8 and recheck sag measurement. When sag measurement is correct, screw the blue air cap on clockwise until snug. Suggested Starting Points for Setting Sag Rider Weight (lbs)Rider Weight (kgs)FLOAT Pressure (psi/ bar)TALAS Pressure (psi/ bar) ...
Use your air pressure to find your rebound setting. Turn your rebound knob to the closed position (full clockwise) until it stops. Then back it out (counter-clockwise) to the number of clicks shown in the table below. Rider Weight (lbs) Rider Weight (kgs) 36/38 FIT4 36/38 GRIP 36/...
Add 0.5-1cc of Float Fluid to the IFP chamber. Install the 8mm Shaft Bullet tool onto the shaft and coat it with a thin film of Slick Honey. Step 39 Reinstall the wire retaining ring into the bottom of the Upper Post making sure to orient the split in the ring so it is positioned...