Pack the new bearings and race in a liberal amount of grease. Slide the rotor onto the spindle, and insert the bearing and race into the spindle. Tighten the spindle nut with a crescent wrench, and reinsert the cotter pin into the nut. Attach the dust cover over the spindle. Step 5 P...
• Thoroughly grease the needle bearing at the rear of the hub assembly (opposite the wheel studs) with a high temperature wheel bearing grease. • Install the studs into the rear of the hub assembly hand tight; threadlocker is optional. • Install the brake rotor rock shield over the ...
Remove the nut from the rear end of the tension strut. The tension strut runs forwards from the bottom end of the suspension, crossing the frame rail. Pull the wheel spindle rearward, separating it from the tension strut. Unbolt the strut from spindle. Pry the joint with a pry bar to r...
Fordor Rear Floor board support October 28 - 09:58 pm How do I clean cowl lamps? October 28 - 09:42 pm Spindle arms and axle Question October 28 - 08:33 pm Newest shop tool non T October 28 - 08:02 pm OT--- Best Ford commercial yet---worth the watch October 28 - 07:...