Socket Head Bolt, 10MM-1.5 x 80MM Rear Block, 5” U-Bolt, 9/16” x 3-1/4” x 12.5” SQ Hardware Pack (U-Bolts) Flat Washer, 9/16” Plain High Nut, 9/16” Plain Hardware Pack (Vent Hose) Vent Hose Connector Vent Hose 3-1/2” Hardware Pack (Rear Brake) E-Brake Bracket ...
the leaf spring perch with a 10mm socket (Fig. 12). On the right side of the axle, pull the plastic clip on the ABS line out of the bracket (Fig. 13). Leave loose at this time. Fig. 12 Fig. 13 Fig. 14 B 12. Set the stock ABS/Brake line tabs back into position and reattac...
Remove the lug nuts from the wheel, and slide the wheel off the axle. Use a ratchet and socket to remove the two mounting bolts from the caliper. Pull the caliper off the rotor, and suspend the caliper with mechanic's wire. Step 3 Pry the dust cap from the spindle with a flat-head...
• Remove the (4) nuts securing the wheel hub assembly to the steering knuckle with a 21 mm socket (located on the backside of the steering knuckle). The nuts are difficult to see, but easy enough to reach with the appropriate socket and a small extension. If the nuts prove difficult ...
Remove the bolts from the skid plate with a socket wrench and pull the skid plate off. Remove the hub nut and washer with a socket wrench. Step 4 Loosen, but do not yet remove, the bolts on the axle shaft. Step 5 Remove the brake pipe and wire support brackets from the upper contro...
6V bulb in 12V socket December 30 - 01:00 am Happy Birthday Stan Howe December 30 - 12:51 am Leaking Ruxstell rear? December 30 - 12:34 am Help on vaporizer December 29 - 10:59 pm Brass Windshield Glass Setting Channel December 29 - 10:06 pm U Joint Housing December 29 -...