Your ESP32 dev board (eg a mini MH-HT-LIVE) may already have a USB socket. If not, eg you have an ESP32-CAM, connect your to the computer USB with a FTDI UART module (pic below). Go to theArduino IDETools menu and set parameters for the chip you have: set the ESP32 developme...
espflash save-image --chip esp32 target/xtensa-esp32-espidf/release/app app.bin Flash binary: openocd-esp32openocd -f /usr/share/openocd-esp32/scripts/interface/ftdi/esp32_devkitj_v1.cfg -f /usr/share/openocd-esp32/scripts/target/esp32.cfg -c "program app.bin 0x10000 reset exit"...
I tried isolating ESP32 and FTDI232H modules together (I was testing with other hardware also). In other words, I connected the 3.3V GND of ESP32 and FTDI232H modules together, but it did not help at all; same problem persists. I am pretty sure I did not meddle with the sdkconfig...
Inconveniently, the ESP32-CAM doesn’t have a USB socket to connect it directly to your computer. To work round this a FTDI module is required. On the right is a 3.3v ftdi which connects to the computer. On the left are dupont leads to connect to the ESP32-CAM. Identify the VCC (...
Info : Listening on port 6666 for tcl connections Info : Listening on port 4444 for telnet connections Info : ftdi: if you experience problems at higher adapter clocks, try the command "ftdi tdo_sample_edge falling" Info : clock speed 20000 kHz Info : JTAG tap: esp32.cpu0 tap/device ...
30(RXD0) - FTDI TX 31(TXD0) - FTDI RXRunning > "idf.py erase-flash" returns "No serial ports found"What do I miss. Maybe all the module's ground pins 1, 2, 11, 14, 36~53 must be connected?mremre Posts: 2 Joined: Wed Aug 23, 2023 5:18 pm Re: ESP32-H2-MINI minimal ...
That’s a free app with premium features, which also means it’s not open source, so any new features would have to be implemented by the developer. I asked him whether ESP32 boards were also supported, but he answered theapp only works with ESP8266 boards. ...
The ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol stack that can give any microcontroller access to your WiFi network. The ESP8266 is capable of either hosting an application or offloading all WiFi networking functions from
# CONFIG_INET_ESP is not set # CONFIG_INET_IPCOMP is not set # CONFIG_INET_XFRM_TUNNEL is not set CONFIG_INET_TUNNEL=m CONFIG_INET_XFRM_MODE_TRANSPORT=y CONFIG_INET_XFRM_MODE_TUNNEL=y CONFIG_INET_XFRM_MODE_BEET=y # CONFIG_INET_LRO is not...
If you bought a USB programmer as you said, that is something differnt than just an FTDI chip or a USB to UART. A USB programmer usually connects one way or another to the JTAG interface. FlashMagic is not for JTAG. If you are talking just a USB to Uart converter, they are not ...