* @return LV_FS_RES_OK: no error or any error from @lv_fs_res_t enum */ static lv_fs_res_t fs_write(lv_fs_drv_t * drv, void * file_p, const void * buf, uint32_t btw, uint32_t * bw) { lv_fs_res_t res = LV_FS_RES_OK; /*Add your code here*/ LV_UNUSED(drv)...
// On NodeMCU 1.0 SD0=MISO, SD1=MOSI, CLK=SCLK to connect to TFT in overlap mode // On NodeMCU V3 S0 =MISO, S1 =MOSI, S2 =SCLK // In ESP8266 overlap mode the following must be defined //#define TFT_SPI_OVERLAP // In ESP8266 overlap mode the TFT chip select MUST connect to ...
https://www.waveshare.com/wiki/ESP32-S3-LCD-1.28 +Firmware: ESP32_GENERIC/firmware_16MiB.bin + + tft_configs/ESP32-S3-LCD-1.28/tft_config.py + 1"""ESP32-S3-LCD-1.28 + 2https://www.waveshare.com/wiki/ESP32-S3-LCD-1.28 + 3Firmware: ESP32_GENERIC/firmware_16MiB.bin + 4""...
flash_hdr) ); print_flash_info(&fhdr); if (!load_partition_table(&bs, PARTITION_ADD)) { ESP_LOGE(TAG, "load partition table error!"); return; } partition_pos_t load_part_pos; if (bs.ota_info.offset != 0) { // check if partition table has OTA info partition //ESP_LOGE("...
binascii.Error: Incorrect padding I doubt if the bootloader will use the same method and went wrong. Secure boot won’t be enabled until after a valid partitions table and app image have been flashed. This is to prevent accidents before the system is fully configured. ...
然后将分区表的 offset 向后调整 ,因为 secure boot v2 会导致 bootloader.bin 的大小变大,原有的空间可能会因容纳不了 secure boot v2 签名后的 bootloader,bin 而导致 overlap。这里可以调整分区表 offset 至 0xf000。 最后使能 secure boot ,注意这里设置的签名秘钥名称要和上一步生成的签名秘钥名称一致,在这...
ESP-IDF v4.4 ESP32 I want to use BLK3 eFuses in a custom efuse table, but they overlap with MAC_CUSTOM* and ADC* fields from the common esp_efuse_table.csv. The same issue was dealt with here, but for ESP32-S3, which has a different esp_...
I was trying to use an OTA with Secure Boot and Flash Encryption. When I trying to build the application it's giving an error. First partition offset 0x10000 overlaps end of partition table 0x11000 I tried to adjust the partition, but th...