* @param file_p pointer to a file_t variable. (opened with fs_open ) * @param pos the new position of read write pointer * @param whence tells from where to interpret the `pos`. See @lv_fs_whence_t * @return LV_FS_RES_OK: no error or any error from @lv_fs_res_t enum *...
// On NodeMCU 1.0 SD0=MISO, SD1=MOSI, CLK=SCLK to connect to TFT in overlap mode // On NodeMCU V3 S0 =MISO, S1 =MOSI, S2 =SCLK // In ESP8266 overlap mode the following must be defined //#define TFT_SPI_OVERLAP // In ESP8266 overlap mode the TFT chip select MUST connect to ...
= SPI_FLASH_RESULT_OK || spiRet2 != SPI_FLASH_RESULT_OK ) { ESP_LOGE(TAG, SPI_ERROR_LOG); return; } Cache_Read_Enable(0); //TODO:write data in ota info } else { if(ota_select_valid(&sa) && ota_select_valid(&sb)) { load_part_pos = bs.ota[(((sa.ota_seq > sb.ota_...
write_len() + write() + bitmap() + pbitmap() + text() + rotate() + width() + height() + vscrdef() + vscsad() + on() + off() + hline() + vline() + rect() + offset() + color565() + map_bitarray_to_rgb565() + jpg() + polygon_center() + polygon() + fill...
Be careful when building the bootloader that the resulting image (.bin) does not exceed 24k, or it will overlap with the partition table. The compiler / linker does not warn about this (at least in IDF 3.0.x). Try setting a lower log level for the bootloader. ...
然后将分区表的 offset 向后调整 ,因为 secure boot v2 会导致 bootloader.bin 的大小变大,原有的空间可能会因容纳不了 secure boot v2 签名后的 bootloader,bin 而导致 overlap。这里可以调整分区表 offset 至 0xf000。 最后使能 secure boot ,注意这里设置的签名秘钥名称要和上一步生成的签名秘钥名称一致,在这...
ESP-IDF v4.4 ESP32 I want to use BLK3 eFuses in a custom efuse table, but they overlap with MAC_CUSTOM* and ADC* fields from the common esp_efuse_table.csv. The same issue was dealt with here, but for ESP32-S3, which has a different esp_...
I also tried by setting the offset to 0x0000, the overlap error gone but after flash, esp not able to read the bootloader. error showing like "failed to read". Contributor ravibhagavandas commented Mar 22, 2021 Hi @Raghav3107 , I think from the error log it looks like the first part...