X 射线衍射 (XRD) 被煅烧的催化剂的度量法在使用 Cu Ka 辐射的 Bruker AXS GMBH D8 进展上被实行 (?= 0.15406 nm).翻译结果3复制译文编辑译文朗读译文返回顶部 X 射线衍射 (XRD) 煅烧催化剂的量测上布鲁克 AXS GMBH D8 提前使用铜 Kα 辐射 (λ = 0.15406 nm)。翻译...
An intelligent Lab X-ray diffractometer (test condition: Cu Ka, wavelength(λ) = 1.5406 A, 45 kV) from 30° to 90° at 2°/min was used to determine the phase constitute. The microstructure was observed by a OLYMPUS GX71 inverted system metallurgical microscope, a JSM6360LV scanning ...
reported for the Cu–Cr–O thin films, the very important aspect of thermal expansion is often neglected. The films are deposited on various substrates at temperatures up to 800 °C, and then, the XRD analysis is generally performed at room temperature. During the deposition process, the subst...
Fig. 2c shows the external quantum efficiency (EQE) of the CZTSSe solar cell as a function of photon wavelength. For comparison purposes, we also include the data for our previous CZTS cell20. The EQE spectrum at short wave- lengths (below , 500 nm) indicates similar absorption originating...
The wavelength was varied between 2000 nm to 200 nm with a 1 nm step size using an direct detector system with the slit width kept at 8 nm. We also estimated the room temperature hole concentration using a permanent magnet (home-made set up) of 0.31 T, for pristine and Ga-...
The chemical composition was determined with the wavelength-dispersive X-ray fluorescence (WDXRF) method, using Rigaku ZSX Primus II apparatus (X-ray tube: end-window with Rh anode, 4 kW power, 60 kV voltage). Calculations of intensities to obtain the chemical composition were performed using st...
Phase analysis was performed using X-ray diffractometry (XRD, Rigaku MiniFlex, Rigaku Co., Tokyo, Japan), and the diffractometer was operated at a 0.15416 nm wavelength, 10 mA current, and 30 kV voltage. XRD patterns were recorded from 5 to 80° in a 2θ range with 0.02° steps. The...
Coordination complexes (1–4) of 2-amino-4-methylbenzothiazole and 2-amino-3-methylpyridine with Cu(CH3COO)2 and AgNO3 were prepared and characterized by UV/Vis and FT-IR spectroscopy. The molecular structure for single crystals of silver complexes (2 an
Especially in the long-wavelength region of simulated illumination, the absorption coefficient is not high enough and needs a higher thickness absorber to fully absorb [29]. The variation of fill factor (FF) with sputtering time is analogous to that of efficiency, as can be seen in Fig. 4(...
irradiation light wavelength should also consider their potential effects on biological tissues. Although the absorption of the NCs at 980 nm was stronger than that at 808 nm, yet under 980-nm laser irradiation, the temperature increase of pure water was much higher than that under 808-nm laser...