ST-LINK device status: HALT_MODE ST-LINK detects target voltage = 3.17 V Vendor = 0x55 Error in initializing ST-LINK device. Reason: ST-LINK: Could not verify ST device! Abort connection. ...OPENOCD... Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-23-20:3...
JLINK_IsHalted() returns FALSE (0002ms, 0504ms total)--- 是否开启了看门狗 导致复位、、 ......
Device selection needs to be updated by Keil from the Keil using STM32 cube programmer and it's working., Keil already has this file defined., Keil already have common startup files for some microcontrollers., It needs firmware to load in SRAM and run to be able to program flash., Is...
Similar problem here - J-Link was working Ok with STM32 targets until a few days ago, then 'could not power up debug port'. If Commander is run, same error message, but does connect (and identify CPU) over SWD. Flash unlock utility does not recognise STM32 device. Strangely enough, ...