谢谢分享啦。
在Debug单击Settings进入Cortex-M Target Driver Setup界面如下图 先选择AT-Link(WinUSB)-CMSIS-DAP/AT-Link-CMSIS-DAP;注意:关于WinUSB,请参考《FAQ0136_如何使用AT-LINK的WinUSB功能提升下载速率》,该文档可以从雅特力科技官方网站→技术与开发支持→FAQ→FAQ0136下载。 Port选择SW,再勾选SWJ; 3. 确认已识别到...
SWD is referenced as SW in the µVision Cortex-M Target Driver Setup. The SWJ box must be selected in ULINK2/ME or ULINKpro. Serial Wire Viewer (SWV) must use SWD because the JTAG signal TDIO shares the same pin as SWO. The SWV data normally comes out the SWO pin or optionally ...
SWD is referenced as SW in the µVision Cortex-M Target Driver Setup. The SWJ box must be selected in ULINK2/ME or ULINKpro. Serial Wire Viewer (SWV) must use SWD because the JTAG signal TDO shares the same pin as SWO. The SWV data normally comes out the SWO pin or Trace Port....
SWD is referenced as SW in the µVision Cortex-M Target Driver Setup. The SWJ box must be selected in ULINK2/ME or ULINKpro. Serial Wire Viewer (SWV) must use SWD because the JTAG signal TDO shares the same pin as SWO. The SWV data normally comes out the SWO pin or Trace Port....
through a USB type-C cable.The new GRAPHICAL USER INTERFACE (Workbench) cuts off overall configuration efforts, guiding the customer in creating a working project in few mouse clicks and detecting mismatches between the target device and customer’s firmware, as well as p...
工程设置对话框 /Utilities 标签设置页 Configure Flash Menu Command z Use Target Driver for Flash Programming :列表选择和调试接口一致的驱动。 Init File 的 设置也和前面调试设置一致。点击 Settings 将进入 Flash Download Setup 界面。 图 5.13. Flash 烧写设置对话框 Download Function :定义了 Flash 烧写的...
through a USB type-C cable.The new GRAPHICAL USER INTERFACE (Workbench) cuts off overall configuration efforts, guiding the customer in creating a working project in few mouse clicks and detecting mismatches between the target device and custo...
“STM32F2xxFlashOn-chipFlash1M”,点击“Add”添加。 第31页/共133页 图3-11选择Flash编程算法 添加好“ProgrammingAlgorithm”的界面如下图所示。 图3-12FlashDownload设置完成 8)设置完成后,点击“OK”“OptionsforTarget”窗口返回到IDE界面。 9)点击Build或者Rebuild对工程进行编译,如下图所示: 第32页/共133...
If one has Chrome or Chromium installed, one can control zeptoforth using the Forth web terminal zeptocom.js using its default settings of 115200 baud, 8 data bits, 1 stop bit, no parity, no flow control, a target type of 'zeptoforth', and a newline mode of CRLF. Note that if one...