然后再点击Use框"ST-Link Debugger"后边的"Settings"按钮,弹出"Cotex_M Target Driver Setup"对话框。把上边红圈上的"Retset and Run"勾选上,这样你每次把程序下载到单片机,它就自动开始运行了。然后看下边"Programming Algorithm"编程算法里边有没有显示出对应的芯片类型,如果没有,Keil将无法将编译好的程序下载到...
然后再点击Use框'ST-Link Debugger'后边的'Settings'按钮,弹出'Cotex_M Target Driver Setup'对话框。把上边红圈上的'Retset and Run'勾选上,这样你每次把程序下载到单片机,它就自动开始运行了。然后看下边'Programming Algorithm'编程算法里边有没有显示出对应的芯片类型,如果没有,Keil将无法将编译好的程序下载到...
谢谢分享啦。
l 在Cortex-M Target Driver Setup窗口使能ITM 激励端口31 l 选择Trace Enable，设置正确的Core ...
STM32F4_新建Keil工程
SWD is referenced as SW in the µVision Cortex-M Target Driver Setup. The SWJ box must be selected in ULINK2/ME or ULINKpro. Serial Wire Viewer (SWV) must use SWD because the JTAG signal TDO shares the same pin as SWO. The SWV data normally comes out the SWO pin or Trace Port....
SWD is referenced as SW in the µVision Cortex-M Target Driver Setup. See page 4, 2nd picture. The SWJ box must be selected in ULINK2/ME or ULINKpro. Serial Wire Viewer (SWV) must use SWD because the JTAG signal TDIO shares the same pin as SWO. The SWV data normally comes out ...
【开发工具】STM32开发环境使用KeilMDK同时进行51开发 【开发⼯具】STM32开发环境使⽤KeilMDK同时进⾏51开发配置51环境·：开发环境的搭建：STM32开发环境使⽤Keil MDK进⾏，那怎么使⽤MDK建⽴⼀个⼯程呢？MDK下载
Select Project | Options for Target ... from the main menu Click the Device tab and select the proper device Click on the Debug tab and make sure that Cortex-M/R J-LINK / J-Trace is selected In order to modify J-Link specific settings click the Settings button in the debug menu and...
debug前,请确定在debug->debugger setting->cortex-M target driver setup->flash download中添加对应的flm文件。 相关例程你在官网中搜索下,还是比较多的。 另外开发时建议使用我们的PDL2.0.2,有比较丰富的examples。参考下安装目录中的QSG文档,还是比较容易从切换到你现在的MCU型...